Operation Manual

AFTER SALES SUPPORT:
Telephone: 1800 269 981
E-mail: support@eurocentra.com.au
AFTER SALES SUPPORT:
Telephone: 1800 269 981
E-mail: support@eurocentra.com.au
22 23
Press the +/= button – the sum of both areas appears in the bottom
section of the display;
Repeat the above mentioned steps, in order to further add up the
measured area.
Volume
Press the MODE button in order to switch to the volume mode and
appears in the display in order to calculate the space volume;
The length symbol “L“ in the display flashes to indicate that the
length measurement is taking place. Press the READ button in order
to measure the length, the result appears in the upper section of the
display. (Step 1)
Area addition in the area mode:
Keep the MODE button pressed down in order to save the calcu-
lated area from the first measurement; at the same time, the “M+”
symbol appears on the display. A double beeping tone will sound;
Press the MODE button in order to delete the currently displayed
data – now the second measurement and calculation can be carried
out (Follows steps 1 and 2 under the Area” section);
After obtaining the desired area from the second calculation, press
+/= in order to switch into the addition mode. The “+“ symbol
appears in the display.
Adding the memory content to the last measurement result: Keep
+/= button pressed down for a minimum of 2 seconds until a dou-
ble beeping tone sounds. “M” disappears from the display, in the
lower row of the display, the value from the memory now appears.
OperationOperation