Owner`s manual

World Class Catamarans
3-9
LIVEWELL PUMP (ALL EXCEPT 270 LC)
Supplies water to the livewell system and is activated by the switch pod. Use the button as
follows:
• Press one time for continuous operation,
• Press two times for a 3 min. “ON” / 3 min. “OFF” cycle
• Press three times for a 5 min. “ON” / 5 min. “OFF” cycle.
MACERATOR PUMP (270 TE / 330 TE)
Used to evacuate waste and debris from fishboxes. Pump is activated using the switch pod
(mid 2004) or toggle switches at the dash (2003 and early 2004).
12V OUTLETS (ALL)
Located strategically throughout the boat, these outlets provide power to aftermarket
accessories such as cell phones, electric reels, and spotlights. Each outlet is independently
wired to the fuse panel.
MARINE HEAD (270 SC / 330 TE)
The marine head is powered by the fuse panel, and has a separate control panel mounted
near the head. The control panel activates the solenoid to allow for water intake and dis-
charge. A macerator pump is incorporated into the head. See Chapter 5 in this manual for
operating instructions.
ANCHOR WINDLASS (OPTIONAL)
Use to deploy and retrieve the anchor. This accessory is controlled by a dedicated switch at
the helm. The fuse is located at the battery management panel.
STEREO (OPTIONAL)
Similar to an automotive stereo, the unit can be operated using the faceplate or a remote
keypad which is mounted near the helm. It is powered by the fuse block, and the memory
wire is connected to a 24 hour circuit.
WINDSHIELD WIPERS (250 DC / 270 EC / 270 SC)
Operated by a rotary switch mounted near the helm, these function identically to those
found on passenger automobiles.
HORN (ALL)
Operated by the digital control unit, these function identically to those found on passenger
automobiles.
ACC (ALL)
“ACC 1” is reserved for the standard freshwater pump on most models. However, the
remaining “ACC” switches can be used to operate aftermarket products. Be aware of the
power requirements for any add-on products, so you do not exceed the capacity of
the breaker supplying the switch. Failure to do so could damage the appliance and/or
the electrical system.