Owner`s manual

World Class Catamarans
5-6
RAW WATER SYSTEM
The raw water pump is located in the aft rigging compartment on the port side, and can be
accessed through the hatch located on the vertical wall beneath the livewell. The pump and wir-
ing are mounted on the rigging wall at the back of the compartment. The raw water pump is
connected to the dual purpose livewell pump which brings in water through a strainer located
on the inboard side of the port sponson. The livewell/raw water seacock must be open for the
system to work, however, the livewell pump does not have to be “ON”. Similar to the freshwater
pump, the raw water system in controlled by a pressure switch set at 45 psi. The pump will
cycle on and off as needed to maintain this pressure. Most owners leave the pump “on” through-
out the day, and use the system when necessary. On the 230SF, the raw water pump feeds the
Hosecoil™ on the starboard side of the leanbar through a y-valve. To view the layout of the raw
water system see the drawing on page 13.
HOSECOIL™
The freshwater and raw water systems can both be operated using the Hosecoil™ wash-
down located on the leanbar. Use the y-valve mounted beneath the Hosecoil™ to select
freshwater or raw water discharge. To operate the Hosecoil™, remove the cover plate and
extend the hose as far as necessary. Open the nozzle by twisting it, adjust to the desired
spray pattern and operate similar to any residential water hose. When you are finished,
close the nozzle and return the hose to the cylinder.
PORTABLE HEAD INSTRUCTIONS
The 230 SF has a portable head located in the console. Below are basic guidelines for the
operation of the head, use them in conjunction with the Thetford™ manual provided in your
“Owner’s Portfolio”.
PREPARATION
1. On the rear of the toilet, slide the locking lever to the unlocked position and separate
the unit.
2. Open the holding tank valve, located on the bottom half of the head, and fill the reser-
voir with the deodorant provided.
3. Complete the preparation by adding enough water to cover the bottom of the tank.
4. Reassemble the unit and fill the freshwater reservoir by removing the cap on the rear
right hand corner of the unit. Replace the cap when finished.
BEFORE USE
1. With the seat cover closed, open and close the holding tank valve located on the front
of the head. This will eliminate any pressure that has built up between uses.
2. Compress the bellows pump located on the rear left hand corner of the unit a few times
to add water to the bowl.
AFTER USE
1. Flush the toilet by pulling the holding tank valve out, and compressing the bellows
pump to rinse the bowl.
2. Push the valve back in completely to ensure an odor tight seal.