Owner`s manual

World Class Catamarans
5-6
RAW WATER SYSTEM
The raw water pump is located in the port aft rigging compartment and can be accessed
through the hatch located on the vertical wall beneath the livewell. The pump and wiring are
mounted on the rigging wall at the back of the compartment. The raw water pump is connected
to the dual purpose livewell pump which brings in water through a strainer located on the
inboard side of the port sponson. The livewell/raw water seacock must be open for the system to
work, however, the livewell pump does not have to be “ON”. Similar to the freshwater pump, the
raw water system is controlled by a pressure switch set at 45 psi. The pump will cycle on and off
as needed to maintain this pressure. Most owners leave the pump “on” throughout the day, and
use the system when necessary. On the 250 DC, the raw water pump feeds the raw water outlet
located aft and outboard of the helm chair. To view the layout of the raw water system see the
drawing on page 14.
PORTABLE HEAD INSTRUCTIONS
PREPARATION
1. On the rear of the toilet, slide the locking lever to the unlocked position and separate
the unit.
2. Open the holding tank valve, located on the bottom half of the head, and fill the reser-
voir with the deodorant provided.
3. Complete the preparation by adding enough water to cover the bottom of the tank.
4. Reassemble the unit and fill the freshwater reservoir by removing the cap on the rear
right hand corner of the unit. Replace the cap when finished.
BEFORE USE
1. With the seat cover closed, open and close the holding tank valve located on the front
of the head. This will eliminate any pressure that has built up between uses.
2. Compress the bellows pump located on the rear left hand corner of the unit a few times
to add water to the bowl.
AFTER USE
1. Flush the toilet by pulling the holding tank valve out, and compressing the bellows
pump to rinse the bowl.
2. Push the valve back in completely to ensure an odor tight seal.
EMPTYING
1. Verify the holding tank valve is closed, then separate the units using the locking lever
on the rear of the head.
2. Remove the waste tank from the hold down brackets and carry to any permanent toilet
facility.
3. Rotate the discharge spout as needed, remove the cap, and depress the air relief valve
to empty.
4. Rinse the tank and refill as directed in the preparation steps above.
WINTERIZATION
1. For cold weather use or storage, fill the freshwater reservoir with any non-toxic anti-
freeze.
2. Add a chemical deodorant to the holding tank.
3. Flush the unit a few times, with the anti-freeze in place, to winterize the bellows pump.