Owner`s manual

World Class Catamarans
5-7
OPTIONAL FEATURES
STEREO
If chosen, your 250 DC can be equipped with an optional JBL™ stereo unit with Sirius™
satellite service. The units are mounted on the vertical wall forward of the head, with 4 speakers
mounted along the port and starboard gunwale. You can control the unit using the faceplate or
the remote located at the helm. Power is supplied to the stereo through the accessory fuse
block; therefore, the “house” battery switch must be in the “on” position for the unit to function.
ANCHOR WINDLASS
You can equip your World Cat with a manual release or freefall windlass manufactured by
Simpson Lawrence™. If you choose this option, you will receive the windlass, an anchor, anchor
rope, and chain which is matched to your vessel’s size. The controls for the windlass are
mounted at the helm, and the manufacturer’s instruction manual is provided, in the “Owner’s
Portfolio”, detailing its use.
The circuit breaker for the anchor windlass is mounted on the battery management panel.
The breaker is connected to the “house” battery switch. If you choose not to have the factory
install your windlass, World Cat provides wires in the deck harness to allow for aftermarket
installs (see wiring diagram on page 10). A plate will be installed on the battery management
panel to cover the opening, but can be removed to install a breaker. Contact your dealer for
more information on aftermarket windlass installation.
OUTRIGGERS
Outriggers enhance the fishability of your catamaran and can be a great asset when hunting
a trophy catch. World Cat offers 15‘ Taco™ outriggers as an option on the 250 DC. The units are
mounted on the fiberglass hardtop and operated using the handles above and outboard of the
console. Use the information provided in Chapter 4 to maintain the aluminum on the outriggers
and grease the telescoping joints frequently to prevent damage from salt spray.
MARINE HEAD
The 250 DC can be equipped with a Galley Maid™ marine head in the port head compart-
ment. The control panel for the head, shown on page 8, is mounted on the vertical wall forward
of the head. Power is supplied to this panel through a 30 amp fuse located in the console on the
accessory fuse block.
Water is supplied to the system from the freshwater tank located in the starboard sponson,
To operate the head, the freshwater system must be pressurized. A switch on the control panel
will activate a solenoid which allows water to fill the bowl.
The holding tank is mounted in the storage box in front of the head compartment, and can
be accessed through the lid on the deck. The deck pumpout fitting is located forward of the
windshield on the port side.
! WARNING
If the solenoid fails or becomes locked in the open position, shut off the supply system
quickly and evacuate the bowl.