Instruction Manual

• The equipment is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the equipment by a person
responsible for their safety.
• Young children should be supervised to ensure they do not play with the equipment. Close
supervision is always necessary when an appliance is used by or near children.
• Unplug the unit from the power outlet before cleaning. Clean the unit only with a dry,
clean cloth. Do not use liquid or aerosol cleaners.
• We assume no liability for any damage caused by noncompliance with these instructions
or
any other improper use or mishandling of the Equipment.
Condensation
The unit may suffer from condensation in the following situations:
• When you take the unit directly from a cold to a warm place, and vice versa.
• When you use the unit in a room where you have just turned on a heater, or where cool
air
from an air conditioner is directed on to the unit.
• When you use the unit in hot and humid surrounds just after having moved it from an
air-conditioned room.
• When the room is steamy or damp.
• If condensation exists, the unit will not operate properly. Remove the disc, plug the power
cord into the wall socket, turn on the unit and leave it for two to three hours. After that
time,
the unit will have warmed up and any moisture will have evaporated. Keeping the
unit connected to the wall socket will keep moisture condensation problems to a minimum.
Getting Started Before First Use
• The unit may become hot during operation. Always leave sufficient space around the unit
for ventilation.
• The voltage supplied to the unit should match the voltage that is printed on the back
panel. If you have any doubts concerning this matter, consult an electrician.
• Avoid placing the unit in direct sunlight or close to any sources of heat. Also avoid
locations subject to vibrations and excessive dust, heat, cold or moisture.
• Do not place the unit on an amplifier or receiver.
• Do not open the cabinet as this might result in damage to the circuits or an electric shock.
If a foreign object gets into the unit, contact your dealer or service company.
• When removing the power plug from the wall outlet, always pull directly on the plug. Do
not pull on the cord.
• To keep laser pickup clean, do not touch it and always close disc tray.
• Do not clean the unit with chemical solvents as this may damage the finish. Use a clean,
dry cloth.