User guide

3
Unpacking
Description
World warm air hand dryer, powered by a universal brush motor, delivers up to 800 watts of drying power and incorporates
an integrated element for heated air. The dryer controls provide for (3) distinct levels of motor operation (Hi, Med and
Low) and the option of operation with, or without, the heating element. An infrared sensor is used to automatically activate
the dryer. These models are intended for use in commercial, industrial, ofce and public facility environments.
Electrical Specications
Table 1
General Safety Information
DANGER
Failure to disconnect the power source before installation or servicing can result in serious
injury or death from electric shock.
• Always disconnect the power source before servicing or installing the hand dryer.
DANGER Failure to properly ground this unit could result in severe electrical shock and/or death.
• This hand dryer must be properly grounded (Earthed) for safe operation. An identied ground connection point is
supplied on the hand dryer’s wall base.
• We recommend GFCI protection in wet or damp locations or as required by local code.
WARNING Risk of re, personal injury or property damage are possible if local codes, or safety
recommendations are not followed.
• Use only the electrical power (voltage and frequency) specied for the model hand dryer being installed. See
Table 1 – Electrical Specications.
• Connect the hand dryer to the nearest suitable distribution panel. The xed wiring must include a disconnection
means complying with local wiring codes.
• To limit a voltage drop, and insure efcient operation, use No. 12 AWG (4 mm2) wire or larger as required by
local electrical codes.
• Always connect to a branch circuit with circuit breaker or fuse protection with an electrical rating greater than the
model hand dryer’s rated amperage shown in Table 1 - Electrical Specications.
• To avoid a hazard due to inadvertent resetting of the thermal cutout, the hand dryer must not be supplied through
an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.
• Each automatic model hand dryer must have a dedicated circuit.
• Route all eld wiring away from moving parts within the hand dryer.
CAUTION Improper mounting could result in personal injury or property damage.
• Follow the mounting height recommendations in Table 2.
• On a stud wall, one side of the hand dryer should be mounted to an existing stud.
1. Remove all packing material. Recycling is recommended.
2. Carefully remove the hand dryer from the shipping carton, using care not to drop the appliance.
3. Inspect carefully for any damage that may have occurred during transit. Check for any loose, missing or damaged
parts. If the hand dryer is damaged, promptly inform the dealer where you purchased it.
Models Type Electrical Input Rated Amperage Rated Watts Certications
K48-XXX Automatic 220 - 240VAC, 50/60Hz 5.0A 1200 CE, TUV-GS
This appliance is not intended for use by young children or persons with physical, sensory or mental disabilities
unless adequately supervised by a responsible person to ensure they can use the appliance safely. Young children
should be supervised to ensure they do not play with the appliance.