Instructions / Assembly

9. Adjust the length of the bottom hex nut on the threaded tube, then ordinal place the

steel washer, plastic washer, diffuser and plastic washer, steel washer on to the

threaded tube, and tighten with the hex nut.

10. Place the bottom cap on to the threaded tube and tighten with the decorative cap.

RELAMPING THE LIGHT BULB(S)

1. Turn off the power to the light fixture.

2. Loosen the decorative cap, and remove the bottom cap, then loosen the hex nut and

remove the steel washers, plastic washers and diffuser.

3. Remove the old light bulb(s) and install the new light bulb(s).

4. Replace the steel washers, plastic washers, diffuser and tighten with the hex nut,

then replace the bottom cap and tighten with the decorative cap.

5. Restore power to the light fixture.

CAUTION: Refer to the re-lamping label located on the fixture. Do not exceed

recommended wattage.

ASSEMBLY DIAGRAM

1. Outlet box

2. Wire connector

3. Neutral (White) wire

4. Ground (bare) wire

5. Live (Black) wire

6. Ground screw

7. Mounting bracket

8. Outlet box screw

9. Canopy assembly

10.Canopy screw

11. Bulb

12. Thread tube

13. Decorative frame

14. Diffuser

15. Steel washer

16. Plastic washer

17. Hex nut

18. Bottom cap

19. Decorative cap