Installation & Asembly

C x 3

Hardware & Tool required

STEP 3 :

STEP 4 :

Page 3/4

Place the balance of Rails (5) equally on the Center Rail (4). Then screw it up with CSK Screw M4 x 32mm (F) on both side of

Rail (5).

Hardware & Tool required

F x 28

D x 3

28x

G x 1

Place the CENTER RAILS (4) on Leg Supports (6). Parallel place three RAILS (5) vertically on the Center Rail (4) as shown with the

center holes lined up. Attach them together by inserting JCBC BOLT M6 x 50mm (C) and Spring Washer

'' (D). Tighten it up with M4

Allen Key (Ball Shape) Long (G).

PAGE 1
STEP 3 : Place the CENTER RAILS (4) on Leg Supports (6). Parallel place three RAILS (5) vertically on the Center Rail (4) as shown with the center holes lined up. Attach them together by inserting JCBC BOLT M6 x 50mm (C) and Spring Washer 41'' (D). Tighten it up with M4 Allen Key (Ball Shape) Long (G). 3x G C D 4 5 6 Cx3 Dx3 Gx1 Hardware & Tool required STEP 4 : Place the balance of Rails (5) equally on the Center Rail (4). Then screw it up with CSK Screw M4 x 32mm (F) on both side of Rail (5).