User's Manual

COMMUNICATION CERTIFICATION LABORATORY TEST REPORT: 73-6848
FCC ID: NQE-900SSHOPPER
Page 82 of 109
Exhibit 8
a specific channel while selecting “scan” will cycle through all available
channels displaying the most recent and peak signal strength values. The
default mode is single channel mode.
(xvii) Test Frequency
Lets you test the sending and receiving frequency of any two radios. The
default is set to 915.0. Available frequencies are 902-928 MHz.
LED Indicators
The front panel on your radio has LED indicators that let you know the unit is
operating properly and that data is being transmitted or received.
•
Status LED. Flashing yellow light lets you know the radio is working properly.
•
Transmitting (TX) LED. Solid red light lets you know data is being
transmitted.
•
Receiving (RX) LED. Solid green light lets you know the data packet is being
received.
v