User's Manual

COMMUNICATION CERTIFICATION LABORATORY TEST REPORT: 73-6907
FCC ID: NQE-900UHOPPER
Page 71 of 103
Exhibit 8
Quick Start Guide
Contents
The World Wireless Communications Micro Hopper Developer Kit contains the following
items:
•
User’s Guide with technical diagrams
•
Micro HopperRadios with RS-232 CIM Boards
•
900 Megahertz Antennas
•
9-volt, 0.5 amp DC Power Adapters
•
Serial Data Cables with 9-pin connectors
Getting Started
You will need to supply the following items:
•
RS-232 terminals or a computers (PC) running a communication software
package
•
Serial COM port for connecting the terminal or computer to the CIM boads.
•
120-volt AC power source for the radio power supplys
•
A standard 25-pin to 9-pin adapter if your PC or terminal does not have a 9-pin
serial port available
Setting up the Radios
1. Locate the antennas and install them on the antenna connectors of the
Hopper radios. Set the radios with antennas aside in a safe place.
2. Remove the 9-pin serial cable from the box and attach it to an available
serial COM port on your PC or terminal. If the port has a 25-pin
connector, use the appropriate adapter, which is not supplied with this kit.
3. Attach the other end of the serial cable RS-232 to the CIM board.
4. Plug the power supply into a 120-volt AC outlet. Power up the radio by
plugging the radio into the CIM board and the cable from the power
supply into the CIM board.
If you are using a terminal or a PC with a communications program other than the Data
Radio Configuration program, set the communications parameters of your terminal to
19,200 baud, 8 data bits, no parity, and one stop bit. You will also want to enable
“local echo” or “half-duplex” mode so that the characters typed will appear on the
screen as well as be sent to the radio.
If you are using a PC with the supplied Configuration program, the following
instructions will explain how to set up your computer for use with the radio.