User's Manual

public 7
ymvC_install.fm document release 2.2 last updated 16/2/17
Installing the YOMOVA countertop
You can call upon a technician or a field engineer to help you install your terminal or you can do it
yourself. If you decide to install the terminal yourself, remember the guidelines below.
• if you decide to install the YOMOVA yourself, neither Worldline nor its vendor will bear any
responsibility or cost for malfunctioning, breakdowns or any anomaly that may result from
incorrect manipulation of the terminal
• read the safety recommendations on page 48 before starting to install your YOMOVA.
• if you notice that any part of the YOMOVA does not fit, blocks or shows any other malfunction,
contact your vendor – do not try yourself to repair or alter it in any way.
• use only accessories (power adaptor, cables and so on) provided by your vendor or by an
approved source
Check that installation/maintenance operations are performed by a trusted person. Log all
maintenance operations, including the name of the operator.
In the tampered state, the device displays a warning message and it is not possible to use the
terminal to make a payment. When a warning message is displayed:
1. remove the terminal from service
2. contact the supplier immediately, who may then report the problem to Worldline
3. keep the terminal available for possible forensic investigation
Unpacking the YOMOVA
1. Open the package and check the contents.
The package should contain a YOMOVA and a mains adaptor. If either of these is
missing, contact your vendor immediately.
Your vendor may also have included paper for the printer, documentation or accessories.
2. Inspect the package and its contents for damage.
If anything is missing or damaged, contact your shipping company immediately and notify
your vendor.
3. Save the box for repacking or moving your equipment in the future.
4. Check the terminal as described in Security recommendations, on page 17.
Preparing a YOMOVA for operation
1. Make sure the location and operating conditions are suitable
2. Install the SAM or SAMS, if required
3. Connect all required communications cables to the terminal
!