User's Manual

mm/dd/yy hh:mm

BATÓÓÓÓÓÓÓÓÓÓÓ-zz%

zz=percent in numbers i.e. 99, 10, 05

Press the STATUS key again to resume processing.

To change the internal battery:

1. Turn OFF the R/F Terminal.

2. Remove the battery holder door on the back of the R/F Terminal by

removing the two screws holding the door in place..

3. Remove the old battery and insert a new one, making sure to orient

the battery with the battery contacts facing the battery connector..

4. Replace the battery door and turn the reader on using the ON/OFF

switch.

5. Sign ON and resume your application.

Recharging the battery:

1. With the RF Terminal shut off, plug the 5V power adapter into the

RF Terminal using the supplied adapter cable.

2. The firmware in the terminal then checks the level of charge in the

battery to see if they need charging, displaying the following message:

Checking Battery

Please Wait………..

3. If the batteries are already charged, the message will disappear. If

the batteries need charging, the following message is displayed:

Charging Battery

Please Wait………..

R/F Terminal Menu Functions

There are four modes of operation for the R/F Terminal:

SIGN ON Signs R/F Terminal on for two-way communication

with host.

SETUP MODE Accesses Setup parameters for Terminal and Base.

ONE-WAY Allows “dumb” data entry to computer. No

prompts from host computer

SITE TESTING Allows user to test range and evaluate site to

determine best position for Base. Also the acid test

for suspected radio failure.

Upon power-up, the R/F Terminal displays the following opening screen: