User's Manual

2
Default RF Terminal Configuration
Parameter Default Setting Parameter Default Setting
Radio Terminal ID 0 MSI Code Disabled
RF Channel 0 check digit not transmitted
Code 39 Enabled Plessey Code disabled
Accumulate Mode ON Label Code5 disabled
stop/start chs not xmit Code 128 Enabled
check digit disabled EAN/UCC 128 disabled
Caps lock OFF
Code 11 Disabled
2 of 5 Code Disabled RSS-14 Disabled
I 2 of 5 Code disabled Code 93 Disabled
6 digit code length Full ASCII disabled
check digit disabled Beep Tone medium
UPC/ EAN Enabled Preamble none
UPC supps disabled Postamble none
UPC-A NSC & check digit
transmitted
Date Format mm-dd-yy
UPC-A NSC & check digit
transmitted
Baud Rate 9600
Parity none
EAN-13 country code &
check digit transmitted
Data Bits 8
Stop Bits 1
EAN-13 country code &
check digit transmitted
Batteries
A
lkaline defaul
t
Speaker Speaker Volume 5 Headphone
Volume 5
UPC-E 1st char & check
digit not transmitted
Laser Options none
Shut Down Time 5 minutes
UPC-E 1st char & check
digit not transmitted
Voice Messages 303015
Characters none reassigned
EAN-8 1st char & check
digit not transmitted
Security Code none
EAN-8 1st char & check
digit not transmitted
Control Keys Only
no
Codabar Disabled Display of year 2 digit
Start/Stop not transmitted Skip opening screens no
CLSI format disabled Aiming Dot No
Automatic Check Back No
Display Backlight
Duration
5 seconds
*All parameters are set back to their defaults when reset using the bar coded Setup Menu, even
parameters that are changed by keypad only. Shaded items are keypad access only.
Using the bar code RF Terminal Setup Menu
To use the bar coded RF Terminal Setup Menu, scan these bar codes in this
order:
 Start Setup - you should hear 2 beeps
 Setup Parameter bar code (i.e. “Beep Tone”)-you should hear 2
beeps for each scan
 Number bar code that corresponds to the appropriate setting
(i.e. “3” to change the Beep Tone to “high”) - you should hear 2
beeps for each scan
 End Setup-you should hear 3 beeps after END SETUP.