User's Manual

18
characters, with the RF Terminal outputting hex 92 every time it sees hex
31. To re-assign characters:
 Scan Characters
 Scan up to seven 4-digit pairings where the first 2 digits represent the
hex number to replace and the second 2 digits represent the hex
number to insert. You can have up to seven character reassignments.
 Scan SET
You can eliminate the output of a character by using FF as the hex number to
insert. For example, if you wanted to eliminate all $, following the above
instructions, enter 24FF.
Beep Tone
Lowest 0
Low 1
Medium 2
High 3
Highest 4
No Beep Tone 5
Date Format
US Format 0
European Format 1
 The US format of mm/dd/yy is the default setting.
 If you switch formats, you must reset the date (SET DATE) in the new
format also.
Set Date
For correct date display, the 6-digit date must be set in the date format you
plan to use. By default the US terminals use the US date format of
dd/mm/yy. If you change the date format, you must re-set the date to
match the new format. For example, to set a date of January 20, 1999, you
would enter 012099 (US format) or 200199 (European format). The date
can be scanned in from the bar coded Setup Menu or entered from the RF
Terminal keypad. To display the date during operation, press the STATUS
key.
D
ate/ Time
D
ate/ Time
Speaker