User's Manual

5
Default Voice MessagesHere are the default messages and the numbers
they are recorded under:
Message Recorded Message #
Prompt
ITEM #01
QUANTITY #02
Error messages
LOW BATTERIES #31
CHANGE BATTERIES #32
TRANSMISSION FAILED #33
Cloning Voice Messages and Setup from RF Terminal to
RF Terminal
If you have several RF Terminals, you can record all of your voice
messages in one RF Terminal and then simply “clone” them to your other
RF Terminals. Cloning also copies the RF Terminal setup (except for
Terminal ID).
You need 2 cables to clone RF Terminals; the Data Cloning Cable #F38
and the Voice Cloning Cable #T15. The Data Cloning Cable plugs into the
“Computer” port on each RF Terminal. This cable must be connected to
clone properly.
One jack on the Voice Cloning Cable has two black rings on it – this end
must plug in to the RECEIVING RF Terminal (the one you are
transmitting to). Plug the single-banded jack end into the MASTER RF
Terminal (the one you are going to record from).
Once both cables are plugged in to both Terminals, go to the Setup Menu on
both Terminals. Select 3 for Voice Operations from the menu.
The “Receiving” RF Terminal must be started first. On the receiving Terminal,
press the 4 key for Cloning Receiver. The “Receiving” unit will display:
Recv Setup/Voice
Please Wait_
Now you can start the “Master” RF Terminal by pressing the 3 key for
Cloning Master. The “Master” Terminal will display:
Xmit Setup/Voice
Please Wait_
During the cloning process, you will hear the voice messages played aloud
as they are copied. The process takes about 75 seconds to complete. After
the Terminals are done cloning, they will both display: