User's Manual

7-6
The “Receiving” RF Terminal must be started first. On the receiving
Terminal, press the 4 key for Cloning Receiver. The “Receiving” unit will
display:
Recv Setup/Voice
Please Wait_
Now you can start the “Master” RF Terminal by pressing the 3 key for Cloning
Master. The “Master” Terminal will display:
Xmit Setup/Voice
Please Wait_
During the cloning process, you will hear the voice messages played aloud as
they are copied. The process takes about 75 seconds to complete. After the
Terminals are done cloning, they will both display:
End of Cloning
Hit Any Key_
If you did not hear the correct messages or you heard no messages at all,
check your cables and receiver/master setup - you may have transmitted
from the wrong RF Terminal.
DATA XMIT ERROR
CYCLE POWER
If you get the DATA XMIT ERROR message, you have to restart the whole
cloning procedure.
Changing the Speaker Volume
The volume of the speaker can be increased significantly by adjusting a tiny
potentiometer inside the RF Terminal. Changing the speaker volume also
changes the headphone volume. The Headphone is an optional feature, Part
#T12, and can be ordered with the RF Terminal or separately afterward. The
#T12 Headphone also has a volume control built into the cable that will change
only the Headphone volume. Because static discharge can cause damage to the
RF Terminal’s circuit board, it is recommended that you use a ground strap or
other grounding device when you are touching the inside of the RF Terminal.
To open the RF Terminal, turn the Terminal OFF and remove the four screws on
the back (one in each corner). Lay the connected halves of the RF Terminal on
a desk or flat surface. You now have access to the Flash RAM EPROM and
several jumpers as well as the volume potentiometer.
Using the figure below, locate the volume control and make adjustments within
the red lines marked on the potentiometer. Use a knife or a very fine blade flat