User's Manual

A-4
Hardware changes on the RF Terminal
To change the Laser decode light operation or the speaker volume, the case
of the R/F Terminal must be opened. Before opening up the R/F Terminal,
be careful of static discharge to the board by grounding yourself (at least
touch some large metal object) immediately before opening the case. To
open up the R/F Terminal, unplug the power supply and turn the R/F
Terminal OFF. Unscrew the four screws - there is one in each back corner.
Lay the two halves of the R/F Terminal on a desk like the diagram below.
• JP3 is the Laser Decode Light jumper. The RF Terminal is shipped
with the decode light on the laser scanner deactivated so that the RF
Terminal can operate interchangeably with a wand or laser. If you
want to restrict the RF Terminal's operation to a laser scanner only and
have the decode light activated, simply move the jumper JP3 from W
to L.