User's Manual

2-1
Chapter 2
RF System Setup
RF Terminal Setup
The RF Terminal itself can be configured using the Terminal keypad or by using
the bar coded Setup Menu. Even if you configure the RF Terminal using the
keypad, you may need the bar coded Setup Menu to use as a reference. Most
users do not need to change anything in the setup. The most commonly changed
setup parameters are the Terminal ID (especially if you have more than 1
terminal) and the Frequency (if you are adding an additional Base station).
Some parameters are available only by bar code menu and others only by
keypad:
Bar Code Menu Only Keypad Only
Characters Security Code
Reset Frequency Bank
Host Response Delay
Relay Existence
Arrow Keys Only
Skip Opening Screens
Display of Year
LCD Display Mode
LCD Backlight Display
If you are using the bar coded Setup Menu and are unfamiliar with scanning bar
codes, see Appendix M; How to scan a bar code to learn proper scanning
technique before you begin scanning the bar codes on the Setup Menu.
RF Terminal Default Settings
This is the default configuration of the RF Terminal as it is shipped from the
factory. If you ever need to return the RF Terminal to these default settings, use
the bar coded Setup Menu and scan the following bar codes in this sequence:
• START SETUP
• RESET
• END SETUP