User's Manual

2-2
Default RF Terminal Configuration
Parameter Default Setting Parameter Default Setting
Radio Terminal ID 0 Disabled
RF Frequency 0 check digit not transmitted
Relay Exist? No Plessey Code disabled
Enabled
MSI Code
Label Code5 disabled
Accumulate Mode ON Disabled
stop/start chs not xmit
Code 93
Full ASCII disabled
check digit disabled mm-dd-yy (if US version)
Code 39
Caps lock OFF
Date Format
dd-mm-yy (if other)
Disabled Beep Tone medium
I 2 of 5 Code disabled Speaker on
6 digit code length
Speaker Operations
Alkaline batteries used
check digit disabled Preamble none
2 of 5 Code
Enabled Postamble none
UPC supps disabled Baud Rate 9600
Parity none UPC-A NSC & check digit
transmitted
Data Bits 8
Stop Bits 1 EAN-13 country code &
check digit transmitted
Security Code none
Frequency Bank 0 UPC-E 1st char & check
digit not transmitted
Laser Options none
Shut Down Time 5 minutes
UPC/ EAN
EAN-8 1st char & check
digit not transmitted
Voice Messages 303015
Codabar Disabled Arrow Keys Only no
Start/Stop not transmitted Characters none reassigned
CLSI format disabled Host Response Delay none
Code 11 Disabled Display of year 2 digit
Code 128 Disabled Skip opening screens no
EAN/UCC 128 disabled LCD Display Mode 0
LCD Backlight Display 0
*All parameters are set back to their defaults when reset using the bar coded Setup Menu, even
parameters that are changed by keypad only. Shaded items are keypad access only.
Using the bar code RF Terminal Setup Menu
To use the bar coded RF Terminal Setup Menu, scan these bar codes in this
order:
• Start Setup - you should hear 2 beeps
• Setup Parameter bar code (i.e. “Beep Tone”)-you should hear 2 beeps for
each scan
• Number bar code that corresponds to the appropriate setting (i.e. “3”
to change the Beep Tone to “high”) - you should hear 2 beeps for each
scan
• End Setup-you should hear 3 beeps after END SETUP.
More than one Setup Parameter can be changed before you scan END SETUP.
For example, if you scanned START SETUP, then “Beep Tone”, then 3, then
“Speaker Operation”, then 1, then END SETUP, this would change the beep
tone to “high”, and turn the speaker "off".