User's Manual

2-3
If you are using a Laser Scanner to setup the RF Terminal, the beam will often
cover more than one bar code. Cover any adjacent bar codes before scanning,
and then check the RF Terminal display to make sure the correct setting was
entered.
Using the keypad to setup the RF Terminal
The RF Terminal can be setup via the Terminals' keypad by entering Setup
Mode from the menu. Turn on the Terminal and press any key. You should see
the SIGN ON? message:
SIGN ON?
KEY [YES/NO]?_
Press the NO key. The next prompt is the SETUP MODE? prompt:
SETUP MODE?
KEY [YES/NO]?_
Press the YES key. At this point, the terminal will ask for a password:
SETUP MODE
PASSWORD?_
Enter WDTRI on the keypad. The next item allows you to choose which item to
configure:
R/F Terminal------->1
R/F Base Setup--->2
Voice Operations->3
Press 1 to enter the RF Terminal Setup. Now you are in the RF Terminal Setup
Menu and can choose from the following options:
RF Setup---0 Speaker--4
BarCodes--1 Other------5
RS232-------2 Exit-------F1
Date/Time--3
At this point, choose which group you want to configure. Most of the RF
Terminal setup parameters are accessible from the keypad Setup Menu (there
are only 2 that are available only from the bar code Setup Menu). Reversely,
there are quite a few options that are available only from the keypad Setup. See
the beginning of this chapter for a comparison of the two Setup Menus.