User's Manual

N-2
CCD Scanners
LI50 Linear Imager Scanner
This CCD scanner reads typical UPC codes from a 0.5” to 7" distance. It
acts just like a laser scanner, except the beam is fuzzier than the lasers sharp
line across the bar code. The cable (rated for 1,000,000 bends). The
warranty is 2 years.
Laser Scanners
The LT7x model RF Terminal is available with an integrated laser scanner
for one-handed scanning. This laser uses the Symbol 1200HP Scan Engine
with a lifetime warranty on the scan element. We also offer cabled laser
scanners (the LZ100, LZ200 and Symbol 3200ER) as an add-on, plugging
directly into the SCANNER port of the RF Terminal.
In addition, we offer the RF Terminal “piggybacked” on a laser scanner.
This option uses the T24 cable to attach the RF Terminal to the top of the
laser. A one-piece carrying case, the T47 is available for the RF Terminal in
this “piggyback” configuration.
The RF Terminal is shipped with the decode light on the laser scanner
deactivated so that the RF Terminal can operate interchangeably with a
wand or laser. If you want to restrict the RF Terminal's operation to a laser
scanner only with the decode light activated, simply move the jumper on
the inside of the RF Terminal from its setting of Wand to Laser. See
Appendix A; Frequency and Jumper Changes, for instructions on how to
get inside of the RF Terminal. The Laser jumper is located immediately
above the EPROM. Move the jumper to the “L” side and put the RF
Terminal back together again.
LZ100 Laser Scanner
This laser scanner uses the Symbol 1200WA Scan Engine with a lifetime
warranty on the scan element. The 10 ft. cable is durability rated for
1,000,000 bends. It reads all densities of bar codes down to a 3 mil narrow
bar and reads a typical UPC code at about 12". The warranty on the LZ100
is 2 years.
LZ200 Laser Scanner
This laser scanner is the equivalent of the lasers used in the integrated
models of the RF Terminal. The LZ200 uses the Symbol 1200HP Scan
Engine with a lifetime warranty on the scan element. The LZ200 is the
laser scanner of choice if you want to use the RF Terminal in the Piggyback
configuration. It can read a 10 mil bar code at 17", a 40 mil bar code at 44 “
ft., and a reflective 100 mil bar code at 9.5 ft. It can read high density code
down to a 3 mil narrow bar width.