User's Manual

N-6
Rubber Boot for RF Terminal
The B11 and B12 Rubber Boot are shipped standard
with every LT7x and T7x RF Terminal order They
are rugged, protective rubber boots intended to protect
the RF Terminal in the most hostile environments.
The B11 is included with every LT7x RF Terminal.
See below for details on installing the Rubber Boot.
Installing the B11 Rubber Boot
To insert the RF Terminal into the Rubber Boot, start
with the laser end of the Terminal first and push the
Terminal as far as it will go into the end of the Boot.
Make sure that the opening at the end of the boot lines up correctly and fits
snuggly over the laser window on the Terminal. Now pull the bottom of the
boot up and over the bottom of the RF Terminal. To remove the boot, pull
the boot off of the bottom of the Terminal, and pull the Terminal out of the
boot.
Case for Booted RF Terminals
There are carrying cases available for all models
of the RF Terminal that will fit over the rubber
boot, providing even more protection against the
elements. The case has a vinyl window covering
the keypad and includes a shoulder strap as well.
T46 Holster for LT
model RF Terminal
with Rubber Boot
The T46 holster was designed with ample room in
order to accommodate the RF Terminal while
encased in the Rubber Boots. The holster is worn
on the belt and gives the operator a convenient place
to store and carry their RF Terminal during use.