User's Manual

2-12
of the Terminal without having to reset this parameter, so the Status Key will
display four lines (starting with RFx9080) as follows:
mm/dd/yy hh:mm
alkBAT-zz%
alk - when Alkaline batteries are specified in Speaker/Battery
setup
rch- when NiMH or NiCad batteries specified in Speaker/Battery
setup
zz=percent or battery life left in numbers i.e. 99, 50, 23
Press the STATUS key again to resume processing.
The next two lines show the following:
TB9080A ID=0 Freq=0
RLY=N 6/6 SC=N C=N
• The first character on the line is:
T for US/Canada Frequency
E for European (includes UK)
A for Australian
G for old UK (458MHz)
K for Korean
• The next character “B” is the board level.
• 9080A is the firmware version
• ID is the Terminal ID assigned (0-F)
• Freq is the Terminal Frequency (0-F)
• RLY=N indicates no relays (Y instead of N indicates Relays
are to be sought)
• 6/6 is a 6 line terminal in 6 line mode; other possibilities are 6/4
and 4/4
• SC=N indicates no Security Code is programmed (if Y, Security Code)
• C=N indicates no Character mapping (if Y, beware, characters are
remapped)