User's Manual

1-1
Chapter 1
Installation
Components
The components in your R/F Terminal system will vary according to the
configuration of your system. Your R/F Terminal shipment should contain at
least:
• An R/F Terminal T7x or LT7x (unit includes keypad and display). If the
R/F Terminal is an LT7x model, it will have an integrated laser scanner
built-in to the body of the terminal.
• An optional Scanner – Laser, Wand or CCD that plugs into the scanner
port of the R/F Terminal. You have a built-in laser scanner if you ordered
the LT7x model. (LT means Laser Terminal)
• A Shoulder Strap and Rubber Boot – which if used, will minimize the
damage from accidental drops in usage. (The shoulder strap has to be
installed with a screw driver per the included instructions)
• A R/F Terminal Setup Menu- this is an 8.5” x 11” laminated sheet
consisting of bar codes used to configure the R/F Terminal.
• Utilities CD ROM – demo programs, DLL, and firmware loader program!
If Base Stations or Relay Stations were ordered with your system, you should
receive at least:
• A Base Station (B5x) and/or Relay Station (R5x) including a 5v power
adapter for each.
• A Serial Cable (F34 or F36) if a Base Station.
• RS422 Y Cables (F44) if using multiple Relay Stations.
• A Test Relay Cable – if a Relay was ordered. This is a short cable just for
testing. Relay cables are much longer and are supplied by the user, (use
CAT 5 or Belden 1227A1 wire.)
Keep the shipping box for the R/F Terminal in the event it is necessary to return
equipment for repair later.