User's Manual

2-28
Leave the cover off of the Base Station and plug in the power supply. You are
ready to configure the Base Station using a RF Terminal.
Base Station Setup using the RF Terminal
Using a RF Terminal that is on the same frequency as the Base, stand close to
the Base Station and turn on the Terminal. The Base Station is setup via the
Terminals' keypad by entering Setup Mode from the menu. Turn on the Terminal
and press any key. Answer NO to all prompts until you see:
SETUP MODE?
KEY [YES/NO]?_
Press the YES key. At this point, the terminal will ask for a password:
SETUP MODE
PASSWORD?_
Enter WDTRI on the keypad. The next item allows you to choose which item
to configure:
R/F Terminal------->1
R/F Base Setup--->2
Voice Operations->3
Choose 2 for RF Base Setup. If the RF Terminal is communicating with the
Base Station, you will see the first Setup Parameter, BAUD RATE displayed on
the RF Terminal screen. If you are not communicating with the Base Station,
you will see the following message:
Transmission Failed.
To Retry, Move Closer
and Press Enter.
F1 to Exit._
Move closer and retry by pressing the ENTER key. If you still fail, check that
the Base Station is jumpered correctly, is powered up and is on the same
frequency as your RF Terminal. If you still have problems, see the
Troubleshooting section of this manual.
If you have successful communication, proceed with your Setup. After changing
each parameter, press the ENTER key to move on to the next parameter.