User's Manual

2-1
Chapter 2
RF System Setup
RF Terminal Setup
The RF Terminal itself can be configured using the Terminal keypad or by using
the bar coded Setup Menu. Even if you configure the RF Terminal using the
keypad, you may need the bar coded Setup Menu to use as a reference. Most
users do not need to change anything in the setup. Some parameters are
available only by bar code menu and others only by keypad:
Bar Code Menu Only Keypad Only
Characters Server IP
Reset Device IP
Starting Channel
SSID
Subnet Mask
Encryption Key
Control Keys Only
Device IP Address
Skip Opening Screens
Display of Year
Date and Time
Aiming Dot Duration
Display Backlighting
If you are using the bar coded Setup Menu and are unfamiliar with scanning bar
codes, see Appendix M; How to scan a bar code to learn proper scanning
technique before you begin scanning the bar codes on the Setup Menu.
RF Terminal Default Settings
This is the default configuration of the RF Terminal as it is shipped from
the factory. If you ever need to return the RF Terminal to these default
settings, use the bar coded Setup Menu and scan the following bar codes in
this sequence:
• START SETUP
• RESET
• END SETUP