User's Manual

2-2
Default RF Terminal Configuration
Parameter Default Setting Parameter Default Setting
Device IP
DHCP Server Used
Server IP
Device Searches
Subnet Mask
255.255.255.0
Starting Channel
1
SSID
Blank
Encryption
None Disabled
check digit not transmitted
Enabled Plessey Code disabled
Accumulate Mode ON
MSI Code
Label Code4 and 5 disabled
stop/start chs not xmit
Code 128
Enabled
check digit disabled EAN/UCC 128 disabled
Caps lock OFF
Code 39
Code 11
Disabled
Disabled
RSS-14
Disabled
I 2 of 5 Code disabled
Code 93
Disabled
6 digit code length Full ASCII disabled
2 of 5 Code
check digit disabled
Beep Tone
medium
Enabled
Preamble
none
UPC supps disabled
Postamble
none
Date Format
mm-dd-yy UPC-A NSC & check digit
transmitted
Baud Rate
9600 UPC-A NSC & check digit
transmitted
Parity
none
Data Bits
8 EAN-13 country code &
check digit transmitted
Stop Bits
1
Batteries
Alkaline default EAN-13 country code &
check digit transmitted
Speaker
Speaker Volume 5
Headphone Volume 5
Laser Options
none UPC-E 1st char & check
digit not transmitted
Shut Down Time
5 minutes
Voice Messages
303015 UPC-E 1st char & check
digit not transmitted
Characters
none reassigned
EAN-8 1st char & check
digit not transmitted
Encryption
none
UPC/ EAN
EAN-8 1st char & check
digit not transmitted
Control Keys Only
no
Disabled
Display of year
2 digit
Start/Stop not transmitted
Skip opening screens
no
Aiming Dot
No
No
Codabar
CLSI format disabled
Display Backlight Duration
5 seconds
*All parameters are set back to their defaults when reset using the bar coded Setup Menu, even
parameters that are changed by keypad only. Shaded items are keypad access only.
Using the bar code RF Terminal Setup Menu
To use the bar coded RF Terminal Setup Menu, scan these bar codes in this
order:
• Start Setup - you should hear 2 beeps
• Setup Parameter bar code (i.e. “Beep Tone”)-you should hear 2
beeps for each scan