User's Manual

2-8
will display six lines as follows:
mm/dd/yy hh:mm
alkBAT-zz%
ServerIP=nnn.nnn.nnn.nnn
DeviceIP=nnn.nnn.nnn.nnn
Ch:=n SSID=xxxxxxxxxxxx
WEP=Y Strength=-nn
alk - when Alkaline batteries are specified in Battery setup
rch- when NiMH or NiCad batteries specified in Battery
setup
zz=percent or battery life left in numbers i.e. 99, 50, 23
• Server IP either shows the Server's fixed TCPIP address; or if
Device searches out the Server, shows 0.0.0.0.
• Device IP either shows the Device's fixed TCPIP address or that
it is determined by a DHCP Server shows 0.0.0.0.
• Ch:=n shows the channel to start using, (the channel of the most
frequently used Access Point).
• SSID=xxxxxxxxxxxx refers to the 12 character network name.
• WEP=Y (or N) shows that the Device is configured with an
encryption key.
• Strength=-nn shows the signal strength from the best Access
Point with the same SSID
Press the STATUS key again to resume processing
Speaker and Headphone Volume Controls
By selecting Speaker in the keyboard Setup Mode, you get to the options to
control the Speaker/Beeper and Headphone volumes. If you are using
headphones, you will want set the Speaker volume to 0 to conserve batteries.
Volume settings possible are 0-9.The prompt for Speaker Volume is:
SPEAKER VOLUME
Enter 0-9 for Volume
Control
Current Value is: 5
The prompt for Headphone Volume is:
HEADPHONE VOLUME
Enter 0-9 for Volume
Control
Current Value is: 5
Other