User's Manual

2-20
in 1/10
th
second increments; i.e., 20 would be two seconds.
Reset
While in Setup Mode, DO NOT scan the RESET bar code unless you want to
set all of the RF Terminal setup parameters back to the factory default settings.
Scanning RESET will erase all changes you have made.
The following serial parameters Baud Rate, Parity, Data Bits, and Stop Bits apply only to
firmware updates and a portable printer such as the Cameo and QL3 printers.
Baud Rate
300 0
600 1
1200 2
2400 3
4800 4
9600 5
19,200
6
Parity
None 0
Even 1
Odd 2
• None is generally used with 8 data bits
• Even or Odd parity is generally used with 7 data bits.
Data Bits
7 bits 0
8 bits 1
Stop Bits
1 bit 0
2 bits 1
Protocol
None 0
XON/XOFF 1
Settings 0 and 1 pertain to use of a serial Printer with your RF Terminal. Use
setting 1 for XON / XOFF if your serial Printer supports it. It DOES NOT apply to
the Cameo and QL3 Printers.
R
S232
R
S232
R
S232
R
S232
R
S232