User Manual

2322
Cordless Limbing and Trimming Chain Saw EN
2322
TROUBLESHOOTING
If your saw does not operate correctly check the following:
PROBLEMS POSSIBLE CAUSES POSSIBLE SOLUTION
• Tool will not start. • Out of battery. • Charge the battery pack.
• Bar / chain overheated.
• Chain too tight.
• Lubrication needed.
• Refer to ADJUSTING THE
CHAIN TENSION section.
• Refer to LUBRICATION
section.
• Chain is loose. • Chain tension set incorrectly.
• Refer to ADJUSTING THE
CHAIN TENSION section.
• Poor cut quality.
• Chain tension set incorrectly.
• Chain needs replacement.
• Refer to ADJUSTING THE
CHAIN TENSION section.
NOTE: Excessive tension
leads to excessive wear and
reduction in life of bar &
chain.
• Refer to sections for
CHANGING THE GUIDE
BAR AND CHAIN.
• Unit runs but does not cut.
• Chain installed backwards.
See Fig. H and illustration.
• Refer to CHANGING THE
GUIDE BAR AND CHAIN
section.