User's Manual

1918
Cordless self-propelled lawn mower EN
1918
PROBLEM SOLUTION
2. Motor stops while
mowing.
A. Release switch lever to turn mower off. Remove safety key, turn
mower over and check that blade is free to turn. Clear any obstruction.
If not free, return to an authorized servicer. Blade should turn freely.
B. Raise cutting height of wheels to highest position and start mower.
C. Has battery been fully charged? Plug in charger and wait for green
light to come on.
D. Avoid overloading the mower. Slow down the cutting pace by
pushing mower slower or raise the cut height. Or both.
3. Mower runs but
cutting performance
is unsatisfactory, or
does not cut entire
lawn.
A. Has battery been fully charged? Plug in charger and wait for green
light to come on.”
B. Release switch lever to turn mower off. Remove safety key. Turn
mower over and check: Blade for sharpness - Keep blade sharp. Deck
and discharge chute for clogging.
C. Wheel height adjustment may be set too low for grass condition.
Raise cutting height.
4. Mower is too hard
to push.
A. Raise cutting height to reduce deck drag on grass. Check each wheel
for free rotation.
5. Mower is
abnormally noisy
and vibrates.
A. Release switch lever to turn mower off. Remove safety key. Turn
mower on side and check blade to ensure it has not been bent or
damaged. If blade is damaged, replace with a replacement blade. If
the underside of the deck is damaged return mower to a Authorized
service center.
B. If there is no visible damage to the blade and the mower still
vibrates: Release switch lever to turn mower off, remove safety key and
remove blade. Rotate blade 180 degrees and retighten. If mower still
vibrates, return the mower to an authorized service center.
6. Battery charger
LED’s not on.
A. Check plug connection.
B. Replace charger.
7. Battery charger
LED does not flip to
green.
A. Battery needs to be diagnosed. Take to authorized service center.
8. Mower not picking
up clippings with
bag.
A. Remove mulch plate when bagging.
B. Chute clogged. Release switch lever to turn mower off. Remove
safety key. Clear chute of grass clippings.
C. Too much cut grass. Raise cutting height of wheels to shorten length
of the cut.
D. Bag full. Empty bag more often.
9. When mulching
there are clippings
visible.
A. Too much cut grass. Raise cutting height of wheels to shorten length
of the cut. Do not cut off more than 1/3 of total length.
B. Check blade for sharpness. Always keep blade sharp.
10. Low or
diminished run-time
after many uses
A. Return to Authorized Service location - may need new battery.