SAFETY AND OPERATING MANUAL BladeRunner® X2 WX572
10 9 11 8 7 12 5 6 20 1 2 4 3 14 13 15
A2 A1 17 18 B2 B1 1 2 1 2 19 B3 3 4 2 C 1 D1
D1 C 2 1 E1 D2 1 2 E2 1 2 F G1
G1 F OFF ON G2 G3 H1 H2 I1 I2
I1 I2 J K 16 L1 L2 L3 L4
L3 L4 M N O P 19 e
1. ON SWITCH 2. OFF SWITCH 3. STABILIZER BRACKET 4. BLADE STORAGE 5. MITER GAUGE 6. TABLE INSERT 7. GUARD KNOB 8. GUARD 9. VACUUM PORT 10. GUARD ARM 11. GUARD ARM CLAMP KNOB 12. RIP FENCE 13. FENCE SLOT 14. MITER SLOT 15. BLADE RELEASE 16. VACUUM ADAPTER (See Fig. K ) 17. BOLT (See Fig. A1) 8 18. GUARD ARM ASSEMBLY KNOB (See Fig. A1) 19. BLADE (See Fig. B2) 20.
TECHNICAL DATA Voltage 230-240V~50/60Hz Rated power 650W No load speed Cutting capacity 3000/min Wood 40mm PVC pipe 30mm Aluminum 10mm Steel Ceramic Stroke Length 3mm 10mm 19mm Blade shank T-shank Blade length 100mm or less Table size Protection class Weight 400X430mm /ll 6.
SAFETY INSTRUCTIONS WARNING! When using electric tools basic safety precautions should always be followed to reduce the risk of fire, electric shock and personal injury including the following. Read all these instructions before attempting to operate this product and save these instructions.
18. Use outdoor extension leads - When the tool is used outdoors, use only extension cords intended for outdoor use and so marked. 19. Stay alert - Watch what you are doing, use common sense and do not operate the tool when you are tired. 20 - Check damaged parts - Before further use of tool, it should be carefully checked to determine that it will operate properly and perform its intended function.
SYMBOLS 12 To reduce the risk of injury, user must read instruction manual Ceramic tile Double insulation Teeth per inch Wear ear protection Incorrect Wear eye protection Correct Wear dust mask Lock RCM mark Unlock Warning: do not expose to rain or use in damp locations Tighten Guard and Guard Arm firmly down onto material, don’t raise up the Guard Arm when cutting.
OPERATING INSTRUCTIONS NOTE: Before using the tool, read the instruction book carefully. BladeRunner®— A compact, easy-to-use table-top tool for cutting wood, metal, plastic, and ceramic tile. Lightweight and portable for use right at the work area. Blade is stationary while user moves the material for easier, more precise work. BEFORE PUTTING THE MACHINE INTO OPERATION 1. All covers and safety devices have to be properly fitted before the machine is switched on. 2.
TROUBLE SHOOTING Symptom 14 Possible Causes Possible Solution Tool will not start when switched on. • Power cord is not plugged in. • Check to make sure power cord is connected well into a working outlet. Poor cut quality • Blade is worn out. • Blade is set incorrectly •Too much vibration in material. •Too much vibration of the saw. • Feed rate too fast. • Make sure the blade is sharp and not broken. • Make sure the blade is installed properly.
www.worx.com Copyright © 2014, Positec. All Rights Reserved.