Use And Care Manual

ManualsBrandsWorx ManualsPower Tool AccessoriesWORX® 20-Volt Lithium-Ion Battery Charger

Battery Charger EN

1. BATTERY PACK*

2. CHARGER

3. CHARGE INDICATOR LIGHT

* Not all the accessories illustrated or

described are included in standard delivery.

We recommend that you purchase your accessories

listed in the above list from the same store that

sold you the battery charger. Refer to the accessory

packaging for further details. Store personnel can

assist you and offer advice.

TECHNICAL DATA

Rated Input voltage 120V~60Hz

Output voltage 20V

Charging current 1.5A/2A

Rated Input power 50W

Charge battery Li-Ion

Charging time (approx.)

45min (1.5A)

1hr (2A)

Protection class

/II

Machine weight 0.46kg

WARNING: This product may contain lead,

phthalate or other chemicals known to the

State of California to cause cancer, birth defects and

other reproductive harm. Wash your hands after use.

This device complies with Canadian ICES-001.

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference,

and

(2) This device must accept any interference

received, including interference that may cause

undesired operation.

WARNING: Changes or modiﬁcations to

this unit not expressly approved by the party

responsible for compliance could void the user’s

authority to operate the equipment.

NOTE: This equipment has been tested and found

to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable

protection against harmful interference in a

residential installation. This equipment generates,

uses and can radiate radio frequency energy and,

if not installed and used in accordance with the

instructions, may cause harmful interference to radio

communications.

However, there is no guarantee that interference will

not occur in a particular installation. If this equipment

does cause harmful interference to radio or television

reception, which can be determined by turning the

equipment off and on, the user is encouraged to

try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment

and receiver.

• Connect the equipment into an outlet on a

circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV

technician for help.

CHARGING PROCEDURE

NOTE: Before using the tool, read the

instruction book carefully.

CHARGING INSTRUCTIONS

1. CHARGING YOUR BATTERY PACK

WARNING: The charger and battery pack

are speciﬁcally designed to work together

so do not attempt to use any other devices. Never

insert or allow metallic objects into your charger

or battery pack connections because an electrical

failure and hazard will occur.

2. BEFORE USING YOUR CORDLESS TOOL

Your battery pack is UNCHARGED and you must

charge once before use.

3. HOW TO CHARGE YOUR BATTERY

CHARGING PROCEDURE

1) Plug the charger into an appropriate outlet.

2) Slide the battery pack into the charger. The

LIGHT (3) will become green and ﬂash to show

charging has started.

3) After charging approx 45min/1 hour, the light

will stay green without ﬂashing, which means

the battery is full, and charging is completed.

WARNING: When battery charge runs

out after continuous use or exposure

to direct sunlight or heat, allow time for the

battery to cool down before re-charging to

achieve the full charge.

CHARGING INDICATOR

This charger is designed to detect some problems

that can arise with battery packs. Indicator lights

indicate problems (see table below). If this occurs,

insert a new battery pack to determine if the charger

is OK. If the new battery charges correctly, then the

original pack is defective and should be returned

to a service center or recycling service center. If the

new battery pack displays the same problem as the