SAFETY AND OPERATING MANUAL Hedge Trimmer WG205E WG206E WG207E WG208E
PRODUCT SAFETY GENERAL Power Tool Safety Warnings WARNING: Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term “power tool” in all of the warnings listed below refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. 2 1) WORK AREA a) Keep work area clean and well lit. Cluttered or dark areas invite accidents.
4) POWER TOOL USE AND CARE a) Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. b) Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired.
SYMBOLS To reduce the risk of injury, user must read instruction manual Warning Wear eye protection Wear ear protection Wear dust mask Do not expose to moisture 4 Remove plug from the mains immediately if the cable is damaged or cut Double insulation Keep hands away RCM approval mark Hedge Trimmer WG205E WG206E WG207E WG208E
4 3 2 1 9 6 7 8 5 1. REAR HANDLE 2. SWITCH LEVER 3. FRONT HANDLE 4. FRONT HANDLE SWITCH LEVER 5. SAFETY GUARD 6. BLADE 7. BLADE SHEATH 8. CABLE STRAIN RELIEF ARM 9. shovel(WG208E) Not all the accessories illustrated or described are included in standard delivery.
TECHNICAL DATA Model no WG205E WG206E Rated voltage WG207E WG208E 220-240V~50/60Hz Rated power 450W 500W Rated no load speed 3200 spm Cutting length 42cm 51cm 54cm 60cm Cutting diameter 16mm 16mm 17mm 20mm Machine weight 3.0kg 3.4kg 3.4kg 3.8kg Protection class / II ACCESSORY Safety guard Blade sheath Shovel(WG208E) 6 1 1 1 We recommend that you purchase your accessories from the same store that sold you the tool.
OPERATING INSTRUCTIONS WARNING! Do not use the product without fitting the guard. 1. ASSEMBLY OF THE GUARD (See Fig. A) Insert the guard into the slot as illustrated in Fig A, and use two screws to fix the guard securely. A 2. FITTING THE SHOVEL (See Fig. B-C) (WG208E) Place the shovel until into place, tighten the screws. You can fit the shovel on both sides (Left hand or Right hand). 3. MAINS SUPPLY CABLE STRAIN RELIEF (See Fig.
TO START YOUR HEDGE TRIMMER There are two switch levers fitted in your Hedge trimmer (2 & 4). Both switch levers need to be depressed for the product to start. Depress and hold the front switch lever (4) and press the switch lever (2). TO STOP YOUR HEDGE TRIMMER Move Hedge trimmer away from cutting area before stopping. To stop, release one of the switch levers. Warning: If any parts are missing, damaged or broken, do not operate your Hedge trimmer until all damaged parts have been replaced or repaired.
damaged area could cause electrical shock resulting in serious injury. If the supply cord is damaged, it should be replaced by a local approved Service Centre. Take care not to expose this tool to rain. I 6. USING THE SHOVEL (See Fig. I) (WG208E) To prevent debris from falling into the area which has yet to be cut or other unintentional places, you can fit the shovel towards the cutting side, then follow Fig G~ Fig H cutting sequence to cut. MAINTENANCE CLEANING Disconnect from mains electrics supply.
Copyright © 2013, Positec. All Rights Reserved.