Cordless Hedge trimmer Taille-haies sans fil Cortasetos Inalámbrico ENG Pag 05 F Pag 13 ES Pag 21 WG250 CTC-WG250-M-060417.
� � � � �� � � � �� � ��� ��� ��� � ��� ��� ��� �� �� �� ��� CTC-WG250-M-060417.
� � � � � � � � � �� � ��� ��� ��� ��� � CTC-WG250-M-060417.
1. REAR HANDLE 2. SWITCH LEVER 3. FRONT HANDLE 4. FRONT SWITCH LEVER (All Around Switch Function) 5. BATTERY PACK RELEASE LATCH 6. CAM LEVER (See B.1) 7. LOCKING BOLT 8. SAFETY GUARD 9. BLADE (See K) 10. BLADE SHEATH 11. BATTERY PACK (See D) 12. CHARGER (See D) 13. CHARGED INDICATOR LIGHT (GREEN) (See D) 14. CHARGING INDICATOR LIGHT (RED) (See D) 15. WALL MOUNT BRACKET (See M.
READ ALL INSTRUCTIONS WARNING: When using electric hedge trimmers, basic safety precautions always should be followed to reduce the risk of fire, electric shock, and personal injury, including the following: 06 1. FOR ALL DOUBLE-INSULATED APPLIANCES 1) Replacement parts When servicing use only identical replacement parts.
Table 1 Minimum gauge for extension cords Ampere rating Volts 120 V more than not more than Total length of cord in feet 25 50 100 150 AWG 0 6 18 16 16 14 6 10 18 16 14 12 10 12 16 16 14 12 12 16 14 12 Not Recommended NOTE - Only the applicable parts of the Table need to be included. Figure 2 Method of securing cord set CORD SET APPLIANCE CORD 10) Avoid Unintentional Starting - Don’t carry plugged-in hedge trimmer with finger on switch.
08 trimmer in rain. c) When replacing batteries, all batteries should be replaced at the same time. Mixing fresh and discharged batteries could increase internal cell pressure and rupture the discharge battery(ies). (Applies to products employing more than one separately replaceable primary battery.) d) When inserting batteries into this product, the proper polarity or direction must be observed. Reverse insertion of batteries can result in leakage or explosion.
SYMBOLS Warning Read the manual Do not expose to rain or water Do not burn Do not dispose of batteries. Return exhausted batteries to your local collection or recycling point. Always charge battery between 36º - 95ºF (2º -35ºC) 1-Hour Charging Time Use inside only To avoid possibility of electric shock, do not use in damp or wet conditions Thermal Cutoff will cut off when the temperature is over 266°F(130°C) WARNING! DO NOT USE THE PRODUCT WITHOUT ATTACHING THE GUARD AND FRONT HANDLE. 1.
10 ply and the green light (13) will illuminate . Then, fully insert the battery pack into the charger to make the connection and the red light (14) will illuminate to show charging has started . A discharged battery at normal ambient temperature will take approximately 1 hour to reach full charge. Charging time may vary due to variable ambient temperatures and battery conditions. When charging is completed the green light (13) will illuminate to indicate end of charge (See D) .
TOP CUTTING Use a wide sweeping motion (See J). A slight downward tilt of the cutting blades in the direction of motion gives the best cutting results. SIDE CUTTING When trimming the sides of the hedge, begin at the bottom and cut upwards (See K), tapering the hedge inward at the top. This shape will expose more of the hedge, resulting in a more uniform growth. MAINTENANCE CLEANING REMOVE THE BATTERY PACK. Use a soft brush to remove debris from all air intakes and cutting blade.
customer. Your warranty is subject to the following conditions: • Proof of purchase date and a valid receipt is produced. • The product has not been misused. • The product has not been used for Professional purposes. • Unauthorized persons have not attempted repairs. • The product has not been used for hire purposes. • The product has not sustained damage through foreign objects, substances or accidents. • Damage is not a result of fitting non-approved accessories.
Designed in Italy. Made in China Conçu en Italie. Fabriqué en Chine Diseñado en Italia. Fabricado en China CTC-WG250-M-060417.
