Use and Care Manual

Cordless Li-Ion Blower/Sweeper EN
10
ASSEMBLY
ASSEMBLING THE BLOWER TUBE
(See Fig. A1 & A2)
Before assembling the Blower Tube(4), be sure
the on/off switch (2) is in ‘’O’’ Off position.
Fit the Blower Tube to the motor housing as
shown in Fig A1. Check if the Blower Tube is
firmly secured.
WARNING! Do not attempt to operate
or disable the On/Off Switch by any
means other than the normal assembly or
removal of the tube.
NOTE: Before disassembling the Blower
Tube, be sure the on/off switch (2) is in ‘’O’’
Off position. Press the Release Button(3) , so
that you can separate the tube. (See Fig. A2)
Do not try to separate the tubes by force or by
using tools.
OPERATION
WARNING! The charger and battery
pack are specially designed to work
together, so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections
because of an electrical failure and hazard will
occur.
1. BEFORE USING YOUR CORDLESS
BLOWER
Your battery pack is UNCHARGED, you must
charge before use.
The battery charger supplied is matched to the
Li-Ion battery installed in the machine. Do not
use another battery charger.
2. CHARGING YOUR BATTERY PACK
The Li-Ion battery is protected against deep
discharging. When the battery is empty,
the machine is switched off by means of
a protective circuit: The machine will stop
running.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool
down before recharging.
SYMBOLS
To reduce the risk of injury, user
must read instruction manual
Li-Ion battery, battery must be
recycled
POSITEC Inc. has established
a partnership with the RBRC
Corporation to recycle any
Positec batteries with the
RBRC-call2recycle seal. For
environmental protection, please
do not discard batteries in the
trash. After the batteries’ life
cycle is ended, then please call
1-800-822-8837 for a free service
that will properly dispose of the
battery.
Wear ear protection