SAFETY AND OPERATING MANUAL Cordless Li-ion Blower/ Sweeper WG549E WG549E.5 WG549E.
General Power Tool Safety Warnings WARNING: Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term “power tool” in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. 1) Work area safety a) Keep work area clean and well lit. Cluttered or dark areas invite accidents.
4) Power tool use and care a) Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. b) Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired.
WARNING! To reduce the risk of injury, user must read and understand instruction manual. 1) Training a) Read the instructions carefully. Be familiar with the controls and the proper use of the appliance; b) Never allow children to use the appliance. c) Never allow people unfamiliar with these instructions to use the appliance.
f) Seek medical advice immediately if a cell or battery pack has been swallowed. g) Keep battery pack clean and dry. h) Wipe the battery pack terminals with a clean dry cloth if they become dirty. i) Battery pack needs to be charged before use. Always refer to this instruction and use the correct charging procedure. j) Do not maintain battery pack on charge when not in use.
SYMBOLS Read the operator’s manual. Wear eye protection Do not use in the rain or leave outdoors while it is raining. Li-ion battery. This product has been marked with a symbol relating to ‘separate collection’ for all battery packs and battery pack. It will then be recycled or dismantled in order to reduce the impact on the environment. Battery packs can be hazardous for the environment and for human health since they contain hazardous substances.
1 2 3 4 5 7 1. Handle 2. On /Off Switch 3. Tube Release button 4. Blower Tube 5. Battery Pack 6. Battery Pack Release Button (See Fig. C) Not all the accessories illustrated or described are included in standard delivery. Cordless Li-ion Blower/ Sweeper WG549E WG549E.5 WG549E.
TECHNICAL DATA Type WG549E WG549E.5 WG549E.9 (520-559-designation of machinery, representative of Cordless Blower Vacuum) WG549E Voltage 20V No load speed Machine weight WG549E.9 Max* Lithium 12500/min Blow speed Charging time WG549E.5 200km/h 3hr approx. 1hr approx. / 1.6kg 1.6kg 1.2kg *Voltage measured without workload. Initial battery voltage reaches Maximum of 20volts. Nominal voltage is 18volts. ACCESSORIES Battery pack Charger 8 WG549E WG549E.5 WG549E.9 1(WA3551.1) 1(WA3551.
ASSEMBLY ASSEMBLING THE BLOWER TUBE (See Fig. A & B) Before assembling the Blower Tube (4), be sure the On/Off Switch (2) is in ‘’O’’ Off position. Fit the Blower Tube to the motor housing as shown in Fig. A. Check the Blower Tube is firmly secured. Warning! Do not attempt to operate or disable the On/Off Switch by any means other than the normal assembly or removal of the tube. Note: Before disassembling the Blower Tube, be sure the On/Off Switch (2) is in ‘’O’’ Off position.
C battery pack from your tool. After recharging, insert the battery pack into tool’s battery port. A simple push and slight pressure will be sufficient. D 4. STARTING/STOPPING (See Fig. D) Starting Move the On/Off switch (2) to the “I” On position. Stopping Move the On/Off switch to the “O” Off position. Warning! The tool runs for a few seconds after it has been switched off. Let the motor come to a complete standstill before setting the tool down. 5. USING THE BLOWER (See Fig.
Copyright © 2014, Positec. All Rights Reserved.