Product Manual

Snow thrower EN
1312
1312
hand-held position is unsafe. i. Abnormal
operation - If you notice the snow
thrower running in an unstable state or
hear abnormal sounds from the engine,
stop the machine, disconnect the power
immediately, and contact your original
distributor.
j. Noise control - When using the snow
thrower, you must respect local laws and
regulations regarding noise control and
environmental protection. To avoid noise
disturbance, you should carefully decide
upon an appropriate operation time and
consider the surrounding conditions.
k. When work is completed - Disconnect
the snow thrower from the power
source when not in use, when changing
accessories, and before performing any
maintenance function.
l. Store safely - Store snow thrower
indoors in a dry area between uses. Keep
in a locked area, where children and
unauthorized users cannot gain access.
Do not store the machine while it is still
connected to the power source. It may
cause damage and injury.
m. Maintain for safety and longevity
- Check for misalignment or binding of
moving parts, breakage of parts, and any
other conditions that may affect the unit’s
operation. If damaged, repair or replace the
damaged part before use. Use only those
replacement parts made for your model.
When replacing any parts, you must strictly
observe the instructions and procedures
described in this manual. Special care
should be paid to any rubber parts, since
these parts may increase the engine load
and decrease its mechanical power if
damaged.
SAFE OPERATION PRACTICES FOR
WALK-BEHIND SNOW THROWERS
WARNING: Use the accessory
or attachment the manufacture
recommended, Use of any other accessory
or attachment may increase the risk of injury.
DANGER!
Do not use hands to unclog chute. Stop motor
before removing debris. Do not walk in front
of running machine. Co not direct discharge at
bystander.
CAUTION!
Use for snow removal only.
WARNING!
To reduce the risk of electric shock - replace
damaged cord immediately.
To reduce the risk of injury, do not operate
without guards in place.
Double insulation - when servicing, use only
identical replacement parts.
A. FOR ALL DOUBLE-INSULATED SNOW
MOVERS
Replacement parts
When servicing use only identical replacement
parts. Replace or repair damaged cords.
B. FOR ALL SNOW MOVERS
1) Do not use on graveled surface unless the
snow mover is adjusted for such a surface
in accordance with the operator’s manual.
2) Keep children away - All visitors should be
kept a safe distance from work area.
3) Dress properly - Do not wear loose clothing
or jewelry. They can be caught in moving
parts.
4) Wear rubber boots when operating the
snow mover.
5) Operation of the snow mover in the
hand-held position is unsafe, except in
accordance with the special instructions
for such use provided in the operator’s
manual.
6) Warning - To prevent electric shock use only
with an extension cord suitable for outdoor
use.
7) Extension cords - To prevent disconnection
of snow mover cord from the extension
cord during operation.
i) Make a knot as shown in Figure 1.
ii) Use one of the plug-receptacle retaining
straps or connectors described in this
manual.
Do