Specifications

®
®
completely stopped before touching
them.
Before your first cut, adjust the mower cutting
height to the desired position., The mower
can be set to one of six cutting heights, with
cutting heights between 3/4" and 2-3/4': To
adjust the cutting height, press the top of cut
lever (6) outwards, at the same time lift or
push down the mower until required height
is selected..
11o
It_OWIING
For' cutting convenience, it may be best to start
mowing at a point close to the power supply
and to work your way away from the supply.
Mow the lawn at a right angle from the power'
supply and place the power cable to side which
has already been cut.
_ Warning:When mowing do not allow
the motor to labor, particularly in
heaw conditions. When the motor labors,
the speed of the motor cJrops and you
will hear a change in the motor sound.
VJt_e, this occurs, stop mowiug. Release
the switch lever and raise the height of
cut. Failure to do so could damage the
machine.
Position
6
5
4
Height of cutting
3/4"
1-1/8"
1-9/16"
3 2"
2 2-3/8"
1 2-3/4"
MAINTENANCE
_ Warni, g: Stop mower aud remove
plug from the power supply before
removing the grass box.
Note:To ensure long and reliable service, carry
out the following maintenance procedures
regularly, Check for obvious defects such as
a loose, dislodged or damaged blade, loose
fittings, and worn or damaged components,
Check that the covers and guards are all
undamaged and are correctly attached to
mower. Carry out any necessary maintenance
or repairs before operating mower° If the
mower should happen to fail despite regular
maintenance, please call our customer helpline
for advice_
BLADE MJZ_gNTENANC= [See L]
Never cam/out any assembly operations
or adjustments w_th the power connected
to the mower. Airways ensure that the
power button is in the off position and
that the power plug is disconnected from
the supply. JUways handle the bgade with
care-sharp edges could cause injury. Use
gloves.
Follow these procedures to remove and replace
the blade. You will need protective gloves (not
provided) and a spanner wrench (not provided)
to remove the blade, Hold the blade (13) and
unscrew the blade bolt (7)anti clockwise using
a spanner wrench. Remove blade and attach
a new one to the blade bolt_ Ensure that the
blade is properly positioned as seen in Fig. K,
then firmly tighten the bolt. DO &lOT OVER
TIGHTEN.
Renew your metal blade after" 50hrs mowing or
2 years ,which ever is the sooner-regardless of
condition.
gf the blade is cracked or damaged replace
it with a new one.
STORAGE:
Rotate _dl=e Upper Handle knob to release
the upper handle.
Always ensure that the power button is in
the off position and that the power plug is
disconnnected from the supply.
Clean the exterior of the machine thoroughly
using a soft brush and cloth. Do not use water,
solvents or polishes. Remove all grass and
debris, especially from the ventilation slots.
Turn the machine on its side and clean the blade
area° If grass cuttings are compacted in the
blade area, remove with a wooden or plastic
implement°
Store the machine in a dry place, Do not place
other' objects on lop of the machine.
Rotate the Upper Handle knob (4) to release
the handle joint, it can be folded.You can carry
the mover by middle carry handle(l!} and front
carry handle{12).(See M.1,M.2)
To aid storage, loosen the lower handle knobs
(16} and fold the handles..
Ensure cables are not stuck or entangled when
®
I
NA-WG712-M-070115,indd 10 2007-1-15 I6:53:01