3-in-1 lawn mower tondeuse à gazon 3 en 1 cortadora de césped “3 en 1” helpline nuMber 1-866-354-worX (9679) en p07 f p17 eS p28 WG718
1 2 3 4 5 9 6 7 8
b A B1 B2 1 B3 2 3 C D1 1 2 D2 10 1 a E F G2 H 11 G1 1/3 3 2 1 I J K
L-1 M-1 L-2 L-3 M-2 M-3 L 6 M N
1. Switch lever 2. Safety button 3. Upper handle 4. Lower handle 5. Safety flap 6. Motor cover 7. Side-discharge cover 8. Cutting height adjustment lever 9. grass collection bag 10. Mulch insert (See F) 11. Side-discharge insert (See G1) * Not all the accessories illustrated or described are included in standard delivery.
TECHNICAL DATA Rated voltages Rated power Rated no load speed Deck diameter Front wheel diameter Rear wheel diameter Cut height Cutting height positions 120v~60Hz 13A 3800/min 19”(48cm) 7” 8¼‘’ 1.5”-3.5”(38–88mm) 6 Grass collection capacity 1.6bushels(55L) Machine weight 53.5lbs(24.
SAFETY INSTRUCTIONS FOR ALL LAWN MOWERS 1) Avoid Dangerous Environment - Don’t use lawn mowers in damp or wet locations. 2) Don’t Use In Rain. 3) Keep Children Away - All visitors should be kept a safe distance from work area. 4) Dress Properly - Do not wear loose clothing or jewelry. They can be caught in moving parts. Use of rubber gloves and footwear is recommended when working outdoors. 5) Use Safety Glasses - Always use face or dust mask if operation is dusty.
10 14) Disconnect Lawn Mower - Disconnect the lawn mower from the power supply when not in use, before servicing, when changing accessories such as blades, and the like. 15) Store Idle Lawn Mower Indoors - When not in use, lawn mower should be stored in an indoor dry and locked-up place - out of reach of children. 16) Maintain Lawn Mower with Care - Keep cutting edges sharp and clean for best and safest performance. Follow instructions for lubricating and changing accessories.
and working. 10. Never leave a running machine unattended. 11. Stop the engine (motor) and wait until the blade comes to a complete stop before cleaning the machine, removing grass catcher, or unclogging the discharge guard. 12. Operate machine only in daylight or good artificial light. 13. Do not operate machine while under the influence of alcohol or drugs. 14. Never operate mower in wet grass. Always be sure of your footing; walk; never run. 15.
SYMBOLS CPSC Danger label. Severing of toes or fingers-Rotary mower blade. Thrown objects from mower deck. Keep bystanders/children away. Safety alert. Slip on slope. Read the operator’s manual. 12 Double insulation ASSEMBLY/ADJUSTMENT ASSEMBLING THE HANDLE (See A & C) 1. Attach the lower handle to the mower body with the bolts and wing nuts. (See A) 2. Attach the upper handle to the lower handle with the bolts and wing nuts. (See A & C) GRASS COLLECTION BAG (See B1, B2 & B3) 1.
OPERATION STARTING (See E) DO NOT connect the extension cord to power source until you have finished reading this manual and you are ready to start mowing. 1. The extension cord must be polarized and will only plug in one way, orient the wide slot with the wide blade into the pigtail. Connect the plug to the mains and switch ON. a. The switchbox is provided with a lock-off button to prevent accidental starting. 2.
RECOMMENDED CUTTNG HEIGHT 14 Type Cut Height Range BAHIA 2”-3” BERMUDA 1/2”-1” BUFFALO 1-1/2”-2-1/2” CARPET 1”-2” CENTIPEDE 1”-2” ST.
after every use. 4. Certain types of grass or grass conditions may require that an area be mulched a second time to fully disperse the grass throughout the lawn. If cutting a second time, it is advisable to cut perpendicular (across) the first cut pattern. DO NOT CHANGE CUT PATTERN IN ANY WAY THAT WOULD CAUSE MOWING DOWN A HILL. 5. Change your cutting pattern from week to week. This will help prevent matting and graining of the lawn.
stone. 5. Check balance of blade. See instructions for blade balancing. 6. Replace blade on mower and tighten securely. Refer to instructions below. BLADE BALANCING (See M) Check balance of blade by placing center hole in blade M-1 over a nail or screwdriver shank M-2, clamped horizontally in a vise M-3. If either end of the blade rotates downward, file that end. Blade is properly balanced when neither end drops. 16 STORAGE Stop the mower and unplug the tool.
Designed in Italy. Made in China Conçu en Italie. Fabriqué en Chine Diseñado en Italia. Fabricado en China Copyright © 2008, Positec. All Rights Reserved.
