Use and Care Manual

3-in-1 Cordless Lawn Mower EN
18
it is able to be move up and/or down in the
wheel bracket.
3) With the wheel in its most forward position
slide it up or down into the desired
position.
4) Repeat the above steps to all four wheels.
6. GRASS BAG FILLING INDICATOR(4)
(See Fig. J)
To alert you that the Grass Collection Bag(5)
is full, the mower provides a Grass Collection
Bag Filling Indicator on the top of the bag.
Empty status: flap floats (a)
Full status: flap falls down (b)
7. REAR DISCHARGE (See Fig. K)
The mower provides a rear discharge function.
Grass clippings will be discharged from the
rear chute of the mower and exit below the
Safety Flap (9).
8. MOWING TIPS
WARNING: Always inspect area where
mower is to be used and remove all
stones, sticks, wire, metal and other
debris which might be thrown by the
rotating blade.
1) Mow across the face of slopes, never up-
and-down. Exercise extreme caution when
changing direction on slopes. Do not mow
excessively steep slopes. Always maintain
good footing.
2) Release Switch Lever(2) to turn mower
“OFF” when crossing any graveled area
(stones can be thrown by the blade).
3) Set mower at highest cutting height when
mowing in rough ground or in tall weeds.
Removing too much grass at one time can
cause circuit breaker to trip, which stops
mower.
4) If a Grass Collection Bag (5) is used during
the fast growing season, the grass may
tend to clog up at the discharge opening.
Release Switch Lever to turn the mower
“OFF” and remove the Safety Key(6).
Remove the Grass Collection Bag and
shake the grass down to the back end of
the bag. Also clean out any grass or debris
which may be packed around the discharge
opening. Replace the Grass Collection Bag.
5) If mower should start to vibrate abnormally,
release Switch Lever to turn the mower
“OFF” and remove the Safety Key. Check
immediately for cause. Vibration is a
warning of trouble. Do not operate mower
until a service check has been made.
6. Always release switch lever to turn
mower “off” and remove safety key
when leaving it unattended even for a
short period of time.
9. MULCHING MOWING TIPS
When using the mulching plug, your new
mower is designed to cut the grass clippings
into small pieces and distribute them back into
the lawn. using mulching fins located inside
the mower deck. Under normal conditions,
the mulched grass will biodegrade quickly to
provide nutrients to the lawn. Please review
the following recommendations for optimum
mulching performance.
1) Avoid mowing when the grass is wet from
rain or dew. Wet grass may form clumps
which interfere with the mulching action
and reduce runtime. The best time to mow
grass is in the late afternoon when the
grass is dry and the newly cut area will not
be exposed to direct sunlight.
2) For best mulching performance, set the
cutting height to remove about one third
of the grass blade length, ideally no more
than 1.5” inches at one time. If the lawn is
overgrown, it may be necessary to increase
the cut height to reduce the pushing effort
and prevent overloading the motor. For
extremely heavy mulching, it is advisable
to first cut at a high cut height setting,
and then re-cut to the final cut height.
Otherwise, make narrower cuts and mow
slowly.
3) For best performance, keep the mower
housing free of built-up grass. From time to
time, turn off mower and wait for the blade
to come to a complete stop. Then unplug
the Safety Key (6) and turn mower on its
side. Using an object such as a stick, wipe