How to Guide

2 in 1 Cordless Lawn Mower EN
17
OPERATION INSTRUCTION
NOTE: Read instruction handbook
before operation this machine.
ASSEMBLY AND OPERATION
ACTION FIGURE
ASSEMBLY
Assembling the handle bar
NOTE: Choose one of the two
holes in the lower handle for
desired handle’s height.
See Fig. A1,
A2, A3, A4,
A5
Assembling grass collection bag
See Fig. B1,
B2, B3, B4
Fitting grass collection bag to
the lawn mower
NOTE: Depress the grass
collection bag slightly to ensure
that it is completely installed.
NOTE: Take the mulching insert
out of the lawn mower before
fitting the grass collection bag.
See Fig. C1,
C2, C3
Checking the battery charge
condition
NOTE: Fig. D1 only applies for
the battery pack with battery
indicator light.
See Fig. D1
Charging the battery pack
NOTE: The batteries are shipped
uncharged. Each battery must be
fully charged before the first mow.
Always fully charge the two
batteries at same time. More
details can be found in charger’s
manual.
See Fig. D2
Fitting/removing battery
NOTE: This machine will only
run when 2 batteries are
installed. Please always use
two batteries with the same
capacity and fully charge the
two batteries.
Using two different sized
batteries or if one battery
isn’t fully charged then the
machine will only run to the
lowest common denominator.
See Fig. E
OPERATION
Battery power indicator on the
machine
See details in BATTERY STATUS
part
IMPORTANT
When only one light is illuminated,
at least one battery is depleted and
needs to be charged, even though
the mower may still be capable
of cutting grass. Continuing to
operate your lawnmower with
the battery in this discharged
condition may reduce the life and
performance of your battery.
When no light is illuminated,
at least one battery is not fully
installed or battery may be
defective, please double check
the batteries are fully seated into
position.
See Fig. F
Starting & stopping
See Fig. G1,
G2
Adjusting the cutting height
WARNING! Stop, release
switch lever and wait until
the motor stops before adjusting
height. The blades continue
to rotate after the machine is
switched off, a rotating blade
can cause injury. Do not touch
rotating blades.
See Fig. H
Selecting the intellicut dial
ECO mode
Select ECO mode when
mowing in everyday conditions,
removing approximately 1’’ of
grass at a time.
TURBO mode
Set the dial to TURBO mode
when cutting dense or
overgrown grass.
See Fig.
I1, I2