How to Guide

2 in 1 Cordless Lawn Mower EN
21
3. Mower runs but
cutting performance is
unsatisfactory, or does
not cut entire lawn.
A. Has battery been fully charged? Plug in charger and wait for
green light to come on.
B. Release Switch Lever to turn mower off. Remove safety key.
Turn mower over and check: Blade for sharpness - Keep blade
sharp. Deck and discharge chute for clogging.
C. Wheel height adjustment may be set too low for grass
condition. Raise cutting height.
4. Mower is too hard to
push.
A. Raise cutting height to reduce deck drag on grass. Check each
wheel for free rotation.
5. Mower is abnormally
noisy and vibrates.
A. Release Switch Lever to turn mower off. Remove safety key.
Turn mower on side and check blade to ensure it has not been
bent or damaged. If blade is damaged, replace with a replacement
blade. If the underside of the deck is damaged return mower to an
Authorized service center.
B. If there is no visible damage to the blade and the mower still
vibrates: Release Switch Lever to turn mower off, remove safety
key and remove blade. Rotate blade 180 degrees and retighten.
If mower still vibrates, return the mower to an authorized service
center.
6. Battery charger LED’s
not on.
A. Check plug connection.
B. Replace charger.
7. Battery charger LED
does not flip to green.
A. Battery needs to be diagnosed. Take to authorized service
center.
8. Mower not picking up
clippings with the Grass
Collection Bag.
A. Remove mulch plate when bagging.
B. Chute clogged. Release Switch Lever to turn mower off.
Remove safety key. Clear chute of grass clippings.
C. Too much cut grass. Raise cutting height of wheels to shorten
length of the cut.
D. Bag full. Empty bag more often.
9. When mulching there
are clippings visible.
A. Too much cut grass. Raise cutting height of wheels to shorten
length of the cut. Do not cut off more than 1/3 of total length.
B. Check blade for sharpness. Always keep blade sharp.
10. Low or diminished
run-time after many uses.
A. Return to Authorized Service location - may need new battery.
11. The battery charger
LED flashes red and the
battery can’t be charged.
A. The battery overheats after continuous use. Remove battery
from the charger and allow it to cool to 42
o
C or less.