SAFETY AND OPERATING MANUAL 3 in 1 Cordless lawn mower WG780E
General Power Tool Safety Warnings WARNING: Read all instructions when using electric gardening appliances. Basic safety precautions should always be followed to reduce the risk of fire, electric shock, and personal injury. Save all warnings and instructions for future reference.
condition; b) Check the grass catcher frequently for wear or deterioration; c) Replace worn or damaged parts for safety; Battery tool use and care 1) Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack. 2) Use power tools only with specifically designated battery packs. Use of any other battery packs may create a risk of injury and fire.
SYMBOLS Read instruction handbook before operation this machine. Only use the battery charger indoors Warning Keep bystanders away Blade continues to rotate after the machine is switched off. Wait until all machine components have completely stopped before touching them. Beware of sharp blades. Blades continue to rotate after the motor is switched off. Remove disabling device before maintenance. 4 Do not expose to rain or water Do not burn Do not dispose of batteries.
1 2 3 4 5 6 7 6 8 11 9 10 3 in 1 Cordless lawn mower WG780E 5
1. Upper handle 2. Switch lever 3. Safety key 4. Lower handle 5. Handle height adjustment lever 6. Lock cam lever 7. Safety guard 8. Battery housing cover 9. Side-discharge cover 10. Cutting height adjustment lever 11. Grass collection bag 12. Mulch insert (See K1) 13. Side-discharge insert (See L1) 14. Screw knob (See C) 15. Battery pack *(See B) 16. Charger *(See B) * Not all the accessories illustrated or described are included in standard delivery.
TECHNICAL DATA Rated power 24 V Rated no load speed 3500/min Cutting diameter 46cm Front wheel diameter 178mm Rear wheel diameter 210mm Cut height 38 – 88mm Cutting height positions 6 Grass collection capacity 55L Battery capacity 17Ah Battery type Lead acid Battery model WA0032 Charging time 16hrs Charger model WA3718 Charger part no. Charger rating QL-09005-B2401500F Input: AC 100-240V, 50/60Hz, 1.5A, Output: 24Vdc, 1500mA Machine weight 36.
INTENDED USE This product is intended for domestic lawn mowing. CHARGER SAFETY RULES 1. Plug charger directly into an electrical outlet. DO NOT ABUSE THE CORD. Never carry charger by cord. Do not disconnect the charger from the outlet or mower by pulling it by the cord. 2. CAUTION: To reduce the risk of fire, electrical shock, or personal injury do not attempt to use this charger with any other product. Likewise, do not attempt to charge the mower with any other charger. 3.
BATTERY CARE The battery in your cordless lawnmower is a 24-volt sealed lead acid system. The mower can be stored in any position without fear of leakage. • For optimal battery life and performance the battery should be fully charged every 2 months during storage • For optimal battery life and performance the battery should be fully charged after each use • Store the battery in a cool dry location. • The battery can be safely stored down to - 4°F (-20°C).
1 2 E1 3. FITTING/REMOVING BATTERY (See E1, E2) REMOVING BATTERY Pull out the battery connector, then rotate the battery locking knob counter-clockwise and then use the battery handle to remove the battery. NOTE: Be careful not to drop the battery onto your foot or on the ground when removing it. FITTING BATTERY Put the battery into the battery container, press the battery connector and then rotate the battery locking knob. 4.
6. ADJUSTING THE CUTTING HEIGHT (See H) WARNING! Stop, release switch lever and wait until the motor stops before adjusting height. The blades continue to rotate after the machine is switched off, a rotating blade can cause injury. CAUTION: Do not touch rotating blades. For the first cutting of the season, a high cutting adjustment should be selected. The lawnmower can be set to 6 cutting heights between 38mm and 88mm.
J 12 K1 12 12 K2 13 L1 2. BATTERY STATUS LED’S (See J) NOTE: Battery Status LED’s are not active in charging mode. The Status LED’s will indicate the battery condition when the button on the battery is pressed. The LED’s constantly senses and displays the battery condition as follows: Press the button “POWERTEST”, the light button is illuminated. When the three green lights are illuminated, the battery is in a highly charged condition.
machine. To assemble the side-discharge, raise the sidedischarge cover and hold it up, position the sidedischarge onto the hooks, then release the cover to lock the side-discharge into position. 6. MOWING TIPS NOTE: Always inspect area where mower is to be used and remove all stones, sticks, wire, metal and other debris which might be thrown by the rotating blade. 1) Mow across the face of slopes, never up-and-down. Exercise extreme caution when changing direction on slopes.
2) 3) 4) 14 5) The best time to mow grass is in the late afternoon when the grass is dry and the newly cut area will not be exposed to direct sunlight. For best mulching performance, set the cutting height to remove about one third of the grass blade length, ideally no more than 38mm at one time. If the lawn is overgrown, it may be necessary to increase the cut height to reduce the pushing effort and prevent overloading the motor.
WEAR PROPER EYE PROTECTION WHILE REMOVING, SHARPENING, AND INSTALLING BLADE. ENSURE THAT SAFETY KEY IS REMOVED. Sharpening the blade twice during a mowing season is usually sufficient under normal circumstances. Sand causes the blade to dull quickly. If your lawn has sandy soil, more frequent sharpening may be required. REPLACE BENT OR DAMAGED BLADE IMMEDIATELY. WHEN SHARPENING THE BLADE: 1. Make sure blade remains balanced. 2. Sharpen blade at the original cutting angle. 3.
edges towards the ground. Assemble the components. Ensure that the edges of the insulator washer hook over the edge of the blade. Align the flats on the square washer (P-4) with the flats on the shaft. Then securely tighten the blade nut. NOTE: If the blade and insulator washer (P-3) are cracked or damaged, replace with new ones. STORAGE (See Q) Q Stop the mower and always remove the safety key. Clean the exterior of the machine thoroughly using a soft brush and cloth.
Copyright © 2010, Positec. All Rights Reserved.
