Installation Instructions

14
EN
09:00pm
Wed. 6-8-2012
7:00am ~ 12:00am
M T W T F S S
09:00pm
Wed. 6-8-2012
7:00am ~ 12:00am
M T W T F S S
09:00pm
Wed. 6-8-2012
7:00am ~ 12:00am
M T W T F S S
09:00pm
Wed. 6-8-2012
7:00am ~ 12:00am
M T W T F S S
09:00pm
Wed. 6-8-2012
7:00am ~ 12:00am
M T W T F S S
09:00pm
Wed. 6-8-2012
7:00am ~ 12:00am
M T W T F S S
09:00pm
Wed. 6-8-2012
7:00am ~ 12:00am
M T W T F S S
09:00pm
Wed. 6-8-2012
7:00am ~ 12:00am
M T W T F S S
Open the panel cover, press
power button,
then input the default PIN
0000.
Press the
key and close
the control panel cover: your
Landroid
®
M will now
find its way to the charging base.
Watch the Landroid
®
M as
it returns to the charging
base and modify the
positioning of the boundary
wire if necessary. When the
Landroid
®
M successfully
returns to the charging base,
this means the installation has
been successfully completed!
Now your Landroid
®
M will
start to fully charge.
2
• If your Landroid
®
M
is outside its territory,
it will not move and
the display will indicate
”outside working
area” error. Just move
it inside its territory and
repeat step 2.
• If your Landroid
®
M is
inside its territory but the
display says “outside
working area” and the
LED is on, it means you
clamped the boundary
wire ends incorrectly.
Just reverse them.
• Your Landroid
®
M should
always remain switched
on. If you ever need to
turn it off, then make sure
you place it within its
boundary area before you
switching it back on again.
• Should your
Landroid
®
M stop
operating unexpectedly,
just press its ON/OFF
key to ON, correct the
problems, press Start
button.
NOTE: If your Landroid
®
M is in the charging base during a time you have programmed it to mow, press STOP then simply
press the Start button to proceed with mowing.
NOTE: Please refer to the Programming and Troubleshooting Guide for more information.
Warning