Installation Instructions

16
EN
Open the keypad window
by pressing the large red
button on the top of your
Landroid
®
L.
Press and hold down the
Power ON/OFF
key
until the Landroid
®
L turns on.
Input the default PIN 0000
Press the
key and close
the keypad window: your
Landroid
®
L will now find its
way to the charging base.
Watch the Landroid
®
L as it
returns to the charging base
and modify the positioning
of the boundary wire if
necessary. When the
Landroid
®
L successfully
returns to the charging base,
this means the installation has
been successfully completed!
Now your Landroid
®
L will start
to fully charge.
4.2
• If your Landroid
®
L is
outside its territory, it
will not move and the
display will indicate
“outside working area”
error. Just move it inside
its territory and repeat
step 4.2.
• If your Landroid
®
L is
inside its territory but
the display says “outside
working area” and the
LED is on, it means you
clamped the boundary
wire ends incorrectly.
Just reverse them.
• Your Landroid
®
L should
always remain switched
on. If you ever need to
turn it off, then make sure
you place it within its
boundary area before you
switch it back on again.
• Should your Landroid
®
L
stop operating
unexpectedly, just press
the STOP button, open
its keypad window, press
its ON/OFF key to ON,
correct the problems,
press
button, shut its
keypad window.
NOTE: Please refer to the Programming and Troubleshooting Guide for more information.
Warning
4. Turn on and test the installation
Place your Landroid
®
L inside the
working area, a few meters from
the back of the charging base.
4.1
This is the exciting part where you can turn your Landroid
®
L on for the first time.