Instructions

11
Cordless Li-Ion handy saw
EN
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The machine is intended for sawing wood,
plastic, soft metal and building materials while
resting firmly on the workpiece.
ASSEMBLY
REPLACING/INSERTING THE SAW BLADE
Remove the battery pack from the
socket before carrying out any
adjustment, servicing or maintenance.
When mounting the saw blade, wear
protective gloves. Danger of injury when
touching the saw blade. When changing the
saw blade, take care that the saw blade holder
is free of material residue, e. g. wood or metal
shavings.
1. SELECTING A SAW BLADE (See Fig. A)
NOTE: Only use maximum blade lengths
specified in table below for the intended
purpose of application. Failure to adhere
to this advice will result in damage to the
product and void of warranty.
Typical application
Pruning blade (152mm,
6TPI, 65Mn)
Garden limbs, etc.
Bi metal blade
(152mm, 18TPI, HSS)
Metals and wood
,etc.
2. INSERTING A SAW BLADE (See Fig. B)
Remove the battery pack from the
socket before carrying out any
adjustment, servicing or maintenance.
Pull down the tool-free blade clamp lever (6),
Insert the blade shank into the blade holder
until it stops. Release the clamp lever (6) to
lock the blade (7/8) in position.
Check the tight seating of the saw blade.
A loose saw blade can fall out and lead to
injuries.
3. REMOVING A SAW BLADE (See Fig. B)
To remove a blade, depress the clamp lever,
pull out the blade.
CHARGING
WARNING: The charger and battery
pack are specially designed to work
together so do not attempt to use any
other devices. Never insert or allow
metallic objects into your charger or
battery pack connections because of an
electrical failure and hazard will occur.
Your battery pack is UNCHARGED and you
must charge once before use
The battery charger supplied is matched to the
Li-Ion battery installed in the machine. Do not
use another battery charger.
1. CHARGING YOUR BATTERY PACK
The Li-Ion battery is protected against deep
discharging. When the battery is empty,
the machine is switched off by means of a
protective circuit. In a warm environment or
after heavy use, the battery pack may become
too hot to permit charging. Allow time for the
battery to cool down before recharging.
2. TO REMOVE OR INSTALL BATTERY
PACK (See Fig. C)
Depress the battery pack release button to
release and slide the battery pack out from
your tool. After recharge, slide it back into your
tool. A simple push and slight pressure will be
sufficient.
OPERATION
1. SAFETY ON/OFF SWITCH (See Fig. D)
Your switch is locked off to prevent accidental
starting. Depress the lock-off button (1) then
the on/off switch (5) and release lock-off button
(1). Your switch is now on. To switch off just
release the on/off switch.
2. WORKING INSTRUCTIONS
NOTE: Hold the machine away from yourself.
Stand in a secure and stable position.
WARNING: Always clamp and
support workpiece securely. Do
not touch blade to workpiece until saw