Owner's Manual

Owner’s Manual EN
10
4. Control panel
Start
1) After the boundary wire installation, you can start using Landroid
®
(Please refer to Installation Guide for boundary wire
installation).
2) Press
until Landroid
®
turns on. For the first use, input the default PIN code 0000 by pressing for four times when
the number 0 is blinking. (The PIN code can be changed, please refer to “
Setting
” in the Installation Guide).
NOTE:
Landroid
®
will turn off if it does not receive any input within 30 seconds after it is turned on. If you enter wrong
PIN code three times, Landroid
®
will raise the alarm “di-di” and then turn off.
3) Press
, then press to start mowing.
4) Press
then to make Landroid
®
go to the charging base.
Landroid
®
will work continuously until reaching low battery power level and then it will return to the charging base. Once
charging is complete, Landroid
®
will automatically resume mowing or it stay in the charging base according to the mowing
schedule.
NOTE: When Landroid
®
turns on, all lights on the display will be illuminated and then turn off. Check if there is any light
damaged. It is recommended to shield the display with your hand when the outdoor light gets too strong.
POWER ON/OFF
Turns Landroid
®
on
and off
Wi-Fi
LOCK
BATTERY CAPACITY
WORKING TIME
START
Starts mowing/
Selects up
STANDBY PAGE:
Landroid
®
is not in the working hours.
SLEEP PAGE:
Landroid
®
is fully charged and
is not in the working hours.
DISPLAY
Displays the state of your
setting
STOP
Stops Landroid
®
during
operation
HOME
Sends Landroid
®
to its
charging base during
operation and activates
charging/Selects down
OK
Confirms any setting/
Enters Wi-Fi connection
mode