Owner's Manual

Owner’s Manual EN
25
Landroid
®
is starting to have
shorter run-times between
charges.
Something is clogging in the blade
disc.
Take off the blade disc and clean it.
The grass is too high and too thick.
Check the Blade Disc and blades, remove
debris and foreign objects from the blades
and Blade Disc.
Landroid
®
is shaking heavily.
Check the blade disc and blades, remove
debris and foreign objects from the blades
and blade disc.
Landroid
®
is not operating at the
correct time.
The clock is not set to the correct
time.
Set the clock to the correct time (refer to
Section 5.4) or by using App.
Programmed cutting times for
Landroid
®
are not correct.
Change the time settings for the mower to
start and stop.
Landroid
®
is manually docked in the
charging base.
Press
then .
The total working time ratio has been
adjusted via mobile App.
Check if the total working time ratio has
been changed.
The battery does not charge as its
temperature rises above 55
0
C in hot
weather or the temperature is below
0
0
C.
Wait until the battery has cooled down or
warmed up.
Landroid
®
cannot correctly dock
with the charging base.
Environmental influences.
Reposition the charging base. Avoid of a
wall, metal or other objects.
Poor connection caused by debris on
the charging strip.
Clean the contact pins located on the
charging base and the charging strip on
Landroid
®
using a cloth.
The boundary wire on both sides of
the charging base is not long enough.
Make sure the boundary wire on both sides
of the charging base is straight for at least
0.8m.
The green light on the charging
base turns on before charging is
complete.
The charging base is overheated or the
temperature is too low.
Place the charging base in a right place or
wait until the temperature has cooled down
or warmed up.
Landroid
®
runs outside the
boundary wire. Landroid
®
does
not mow an area within a
boundary wire zone. Landroid
®
reverses or rotates erratically
near the boundary wire.
The lawn is wet, uneven or there are
obstacles.
Wait until the lawn is dry. Make the lawn
even and remove obstacles.
The boundary wire has been installed
with tight corners.
Check the boundary wire to ensure the
corners are smooth.
In wet conditions, the boundary wire
electric signal may leak were wire has
been joined or repaired.
Check boundary wire joints. Insulate to
provide a fully waterproof connection.
The cutting area is larger than the
allowable cutting area for Landroid
®
.
Reduce the cutting area or use Landroid
®
with a larger allowable cutting area.
Landroid
®
wheels skid or
damage lawn.
Foreign obstacles, such as twigs
and branches may be lodged under
Landroid
®
.
Remove foreign objects from underside of
Landroid
®
.
The lawn is too wet. Wait until lawn has dried.
The boundary wire has been installed
with tight corners.
Check the boundary wire to ensure the
corners are smooth.
Landroid
®
exits the boundary
wire due to high speed when
going down a hill.
The boundary wire is placed on a
slope steeper than 17% (10°).
Reposition the boundary wire away from
slopes that are steeper than 17% (10°).
Please refer Installation Guide for details.
Wi-Fi connection failure occurs. Reconnect Wi-Fi according to section “
APP
”.
Software update failure occurs.
Try again according to section “
Software
update”
.